IPS-800CE-D16 & IPS-1600CE-D16 - User’s Guide
Internet Power Switch v1.41h | Site ID: (undefined) |
|
|
|
|
| |||||
Plug | Name | Password | Status | Boot/Seq. Delay | Default | ||||||
ON | 0.5 | Secs | ON | + | |||||||
1 | (undefined) | (undefined) | |||||||||
2 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
3 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
4 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
5 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
6 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
7 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
8 | (undefined) | (undefined) | ON | 0.5 | Secs | ON | |||||
| + | ||||||||||
“/H” | for help. |
|
|
|
|
|
|
|
|
|
|
IPS> |
|
|
|
|
|
|
|
|
|
|
|
Figure 5.2: Plug Status Screen - Text Interface (IPS-800CE-D16 Shown)
c)Via Network: The IPS includes a default IP address (192.168.168.168), which allows you to contact the unit from any network node on the same subnet. When the IPS is installed in a working network environment, it is recommended to redefine the IP Address, Subnet Mask, and Gateway Address as described in Section 5.3.3.
i.Telnet to the IPS’s IP address. For example, if the IP address is "192.168.168.168", then on a UNIX system, the Telnet command would be:
$ telnet 192.168.168.168 [Enter]
ii.If the Telnet connection is refused, this may mean that either the IP Security feature has denied the connection (See Section 5.3.4.1), or that the unit is operating on a
2.Password: If the System Password has been defined, the unit will display the Password Prompt. Key in either the System Password or Plug Password, and press [Enter]. If the System Password has not been defined, the prompt will not be displayed when the unit is accessed via the Text Interface. Note that the Password feature is case sensitive.
3.If a valid System Password or Plug Password is entered, the IPS will display the Plug Status Screen shown in Figure 5.2, followed by the "IPS>" Command Prompt.
Note: The Plug Status Screen will not display actual passwords. Instead, the password column will read either "defined" or "undefined."