Tut Systems SMS2000 manual Configuring Smtp, Restoring the Default Configuration

System Administration

sms2000% restore config

Note: You must reboot the SMS2000 for the restored configuration to take effect.

Restoring the Default Configuration

To restore the SMS2000 to the default configuration (with no functions configured), use this command:

set default

For example, to reset the SMS2000 configuration to default, type:

sms2000% set default

Note: This command does not change the password.

Configuring SMTP

Setting the SMTP Server

The command set smtp-serverstarts proxying SMTP sends to the specified SMTP server. Many mail (SMTP) servers reject mail sent from users who are behind a NAT device. To compensate for this, an ISP can install a mail server that accepts mail from each SMS2000. When a subscriber wants to send mail, the SMS2000 can automatically proxy the mail to the ISP’s mail server, which can then cleanly forward it to its final destination. Many SMTP servers do not forward e-mail from hosts outside the local network. It is recommended that you use a local SMTP server. For example, if you have a computer with an IP address in the same subnet as the SMS2000 that can send e-mail, use the SMTP server configured for your e-mail program.

To redirect Simple Mail Transfer Protocol (SMTP) sends to a specified SMTP server, use this command:

set smtp-server{server_name ip_address}

For example, to route all outgoing mail messages through an SMTP server with the IP address 1.2.3.4, type:

sms2000% set smtp-server 1.2.3.4

Deleting the SMTP Server

To stop SMTP proxy sends to the specified SMTP server, use this command:

TUT Systems, Inc Page 29 of 104 P/N 220-06288-20