KEY PRESS | PROMPT | FUNCTION |
| HW Monitor | Upon each succeeding press of the Right arrow, the |
Down arrow | Display | value of the following appear, depending on your |
five (5) times |
| settings under HW Monitor List Configure |
|
| (down arrow eighth time – see below): |
|
| HWM Display (default is Yes) |
|
| VCC 2.6V |
|
| VCCP |
|
| VCC 3.3V |
|
| VCC 5V |
|
| Fan 1 |
|
| Fan 2 |
|
| Fan 3 |
|
| CPU Temp |
|
| Local Temp |
|
| Sys Temp |
|
| VID |
| Performance | Upon each succeeding press of the Right arrow, the |
Down arrow | Display | value of the following appear, depending on your |
six (6) times |
| settings under Performance List Configure |
|
| (down arrow ninth time – see below): |
|
| Perfor Display (default is Yes) |
|
| CPU Usage |
|
| Memory Usage |
|
| Disk Usage |
|
| ETH0 Flow Speed |
|
| ETH1 Flow Speed |
|
|
|
| Urgency Alert | Upon pressing the Right arrow, the following prompt |
Down arrow |
| appears, allowing you to enable urgency alert: |
seven (7) times |
| Enable Alert? (default is Yes) |
|
| Press S (Select) to enable urgency alert. |
|
|
|
| HW Monitor | Upon each succeeding press of the Right arrow, the |
Down arrow | List | following appears. Select which value(s) to display |
eight (8) times | Configure | under HW Monitor Display (down arrow fifth |
|
| time – see above): |
|
| HWM Configure (default is Yes) |
|
| VCC 2.6V |
|
| VCCP |
|
| VCC 3.3V |
|
| VCC 5V |
|
| Fan 1 |
|
| Fan 2 |
|
| Fan 3 |
|
| CPU Temp |
|
| Local Temp |
|
| Sys Temp |
|
| VID |
|
|
|
46
http://www.TYAN.com