Tyan Computer B2094T15 warranty Installing an Expansion Card

Page 42

6.2Installing an Expansion Card

Your system supports one PCI slot located on a riser card. You can install a PCI expansion card for additional or enhanced functions. Follow this procedure to install an expansion card:

1.Before you purchase a PCI expansion card to add to the system, make sure that the card is less than 7 inches (177.8 mm) long. Otherwise, it will not fit into the place.

2.Open the cabinet cover (see section 6.1 in this chapter).

3.Remove the screw, lift the small retainer, and then the metal slot cover. Keep the cover for future use when you remove the card.

Retainer

4.Firmly press the expansion card’s edge connector into the expansion slot and secure the retainer with the screw.

5. Replace the cabinet cover.

42

http://www.TYAN.com

Image 42

Contents Transport GS10 B2094T15 Table of Contents Installing Software Drivers Safety Precautions Introduction Before You BeginUnpacking Product Description Specifications MemorySystem View Front ViewRear View Page Cabinet Installation System Assembly Flowchart System Assembly Installing the CPUOpening the Cover Page Installing System Memory Installing a Hard Disk Drive Installing a Riser Card Rack Mounting Cabinet Slides and EarsPage Cabinet into the Rack Locking TabSetting Up the System System RequirementsPlacing the System Making the Connection Configuring the System Using the LCD ConsoleBefore You Begin Setting the Configuration For LinuxFor Windows Rebooting the System Powering Down the SystemSetting Up With the Web Browser Linux RedHat Installation Notes First possibilityPage Configuring the System Bios Setup ProgramStarting Bios Setup Main Menu Advanced MenuCPU Temperature System Temperature Power Menu Security MenuBoot Menu Exit MenuJumper Settings Jumper Definition Setting DescriptionInstalling Software Drivers Installation Instructions for WindowsInstallation Instructions for Linux RedHat LCD DriverRAID Redundant Arrays of Inexpensive Disks Driver Driver CD \Promise\20276\Linux directoryPress Ctrl+Alt+F7 and click Exit to exit the installation Page Page Expanding the System Opening the CoverInstalling an Expansion Card Adding a Secondary Hard Disk Drive Secondary IDE Connector With a Secondary Hard Disk Drive Installed Adding a CD Drive for test purposeWithout a Secondary Hard Disk Drive Installed Using RAID About RAIDCreating an Array FastBuild Utility main menu appears on the screenCreating an Array for Performance RAID Creating a Security Array RAID 1 wi th New DrivesViewing Drive Assignments ChannelID Drive Model CapacityMB AssignmentChanging the Array Deleting an ArrayRebuilding a Mirrored Array Highlight the array with Critical status and press Enter Appendix DanishTechnical Support FrenchDocument # D1532-100