Omega manual OMB-DAQBOARD-500 Series, Installation Guide, Reference Note

OMB-DAQBOARD-500 Series Installation Guide

This guide tells how to complete the following steps for a successful installation.

Step 1	–	Install Software …… page 2
Step 2	–	Install Boards in Available PCI Bus-Slots …… page 3
Step 3	– Configure Boards ….. page 5
Step 4	– Test Hardware ….. page 6

Reference Note:

After you have completed the installation you should refer to the electronic documents that were automatically installed onto your hard drive as a part of product support. The default location is in the Programs group, which can be accessed from the Windows Desktop.

You should keep your DaqBoard’s serial number and your DaqView/500 authorization code (if applicable) with this document. Space is provided below for recording up to 4 board numbers and their PCI bus-slot locations. The board serial number and board type (500 or 505) is located on the solder-side of the board.

Board Identity on “Solder-Side” of the Board

Board Type	Serial Number	PCI Bus-Slot Location
(e.g. /500, /505)

Board 1

Board 2

Board 3

Board 4

The host PC can support up to four Boards.

DaqView/500 Authorization Code ____________________________

Customers who ordered DaqView/500 can find their authorization code on the authorization code sheet located inside the sleeve of the install CD.

Customers who did not order DaqView/500 can run a 30-day free trial version, as discussed elsewhere in the User’s Manual.

CAUTION

Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)

Use care to avoid touching board surfaces and onboard components. Only handle boards by their edges (or ORBs, if applicable). Ensure boards do not come into contact with foreign elements such as oils, water, and industrial particulate.

© 2004, 2005 947994 1138-0940,rev 1.1 IG-1