Omega Vehicle Security LDN-PS manual Safety Information, Service Safety

Page 5

2.0: Safety Information

PSIM-AC PSIM-DC PSIM-5V

This equipment is designed as safety Class 1 apparatus to comply with EN61010-1.

Service Safety

This equipment has been designed and tested to meet the requirements of the Low Voltage Directive (1997) and has been supplied in a safe condition. This manual contains information and warnings that must be followed by the user to ensure safe operation and to retain the apparatus in a safe condition.

CAUTION: Power Source. The PSIM-AC unit should be connected to the mains supply via a suitable lead with a IEC320 socket. The user should fuse this connection with a suitable fuse. Refer to Specification. Apply no more than 265V rms. (AC) between supply conductors and ground.

WARNING: Do not operate in an explosive atmosphere.

Terms and Symbols in this Manual

WARNING statements identify conditions or practices that could result in personal injury or loss of life. CAUTION statements identify conditions or practices

that could result in damage to the equipment or other property.

This symbol indicates where applicable cautionary or other information is to be found.

WARNING: Do not remove covers or panels.

To avoid personal injury, do not remove covers and panels. Do not operate the equipment without the covers and panels fitted. There are no internal adjustments required during the commissioning of the equipment.

 

 

4

 

LDN-PS

 

 

 

M-3340/1206

 

 

 

Page 4 Page 6
Image 5
Page 4 Page 6
Contents LDN-PS Servicing North America Servicing Europe OMEGAnet On-Line Service Internet e-mail Info@omega.comIndex Dimensions and Mechanical InstallationIntroduction IntroductionService Safety Safety InformationSafety Information Psim Variants General InformationPsim General Layout General InformationPsim used in a small network configuration Psim Schematic and Pin-out Psim Schematic and Pin-out PSIM-ACPSIM-DCPSIM-5V Power Supply Dimensions and Mechanical InstallationPSIM-ACPSIM-DCPSIM-5VPsim Dimensions and Mechanical Installation PSIM-ACPSIM-DCPSIM-5VDC Output SpecificationInput Reverse connection PSIM-AC PSIM-DC PSIM-5V Approvals EnvironmentalApplications Orbit Module with T-CON Standard 2m Comms Voltage Drop EstimationVolt drop From no load output = 5.3 x N = 2 x N x L+1 mVApplication 1 Basic Small Network Connection Applications Calculation for V2 volt drop Calculation for V1 volt dropPSIM-AC PSIM-DCPSIM-5V Applications Application 4 Modules located a long distance from computer Application 5 Use with RS232 Interface Module RS232IM WARRANTY/DISCLAIMER OMEGA…Of Course
Top Page Image Contents