Omega Vehicle Security OM-550 manual Printer, Paper Life, Digital Interface RS-232, Conversion

Page 55

PRINTER
TYPE:	24-Column Thermal
PAPER ROLL CAPACITY:	82 ft ±1.6 ft
LINE HEIGHT:	0.150 inches per printed line
LINES PER ROLL:	6,560 ±128
PAPER LIFE
(Printing 5 channels every 10-min.)	Approximately 217 hours or 9 days
DIGITAL INTERFACE (RS-232)
COMMUNICATION FORMAT:	9600 baud, No parity, 8 data bits, 1 stop
	bit
OUTPUT VOLTAGES:	± 9 VDC
A/D CONVERSION
RESOLUTION:	±20,000 counts
TECHNIQUE:	Dual slope, selectable 50/60 Hz rejection
CHANNEL CAPACITY
NUMBER OF INPUT CHANNELS:	5 Voltage or Thermocouple, 1 Pseudo-
	math
INTERNAL DATA STORAGE
MAXIMUM CAPACITY:	28 Kbytes or 7000 data samples
ENVIRONMENTAL
OPERATING AND STORAGE
ENVIRONMENT:	Indoor use only
OPERATING TEMPERATURE RANGE:	0°C to 50°C (32ºF to 122ºF)
STORAGE TEMPERATURE RANGE:	-25°C to 75°C (-13ºF to 167ºF)
OPERATING RELATIVE HUMIDITY
RANGE:	Maximum 80% R.H. for temperatures up
	to 31ºC decreasing linearly to Max. 50%
	R.H. at 40ºC, remaining constant from
	40ºC to 50ºC.
STORAGE RELATIVE HUMIDITY
RANGE:	Max. 95% R.H., non-condensing
MAINS VOLTAGE FLUCTUATION
RANGE:	Maximum +10%

This is the maximum fluctuation from the nominal rated input voltage for the AC

Power Adapter.

OM-550

u50u

Image 55

Contents Table of Contents Date Time ∙ The OM-550 Datalogger may be referred to as Logger IntroductionProduct Usage Warnings Operator Safety InformationFor protection of the OM-550 itself, observe the following Unpacking OM-550 Features FeaturesOM-550 features Activity LED & Horn Keypad ∙ ON-OFF ∙ RUN ∙ PROG/EXIT ∙ Stop∙ OK ∙ Optional Connectors Channel ConnectorsApplication To remove the Viewing Window Printer WindowSerial Data Port Battery CoverThermal Paper DC JackTilt Stand Gain AdjustPower Supplies Probe SET InputsVoltage Transducer Inputs ProbesType Thermocouple InputsData Cache Programmed FeaturesStatistics LOW Battery Operation POWER-SAVE ModeBattery Check Battery Installation Power ConnectionConnecting the DC Power Cable Connecting the AC Power AdapterPaper Installation PIN Adapter Data Port Connection∙ Programming outline 1. Select Channel ProgrammingProgramming Keys Position Print FormattingVoltage Channels Temperature ChannelsMath PSEUDO-CHANNEL This Interval Overrun can be avoided in two ways LOG IntervalNot Printing Operation AT Full Cache Recording Time Rejection Frequency Temperature UnitsTo return to Normal mode Calibration ModeTadjust R1 = 2 R2 = V-2 Voltage Input ScalingMatching Transducers to the OM-550 Matching a Voltage Transducer= 2.0000 VDC = R1 Matching a Current TransducerR1 = 2 Data Scaling mX + b calculation Matching and Scaling a Voltage Transducer VDC Example Matching and Scaling a Current TransducerU38u Unit Labels Programmed Information OperationLog Interval Time Temperature Units Enter a Tadjust value, or press OK to finish programming U44u Manual Reset programs the OM-550 as follows Appendix a Calibration ∙ Manual Reset∙ Performing a Manual Reset Setup ∙ Calibration Procedure∙ Thermocouple Adjustment Procedure ∙ Voltage Adjustment ProcedureTo return to normal operation ∙ Exiting CAL ModeVoltage Measurement Inputs Appendix B SpecificationsAccuracy Conversion PrinterPaper Life Digital Interface RS-232Connectors POWER/CURRENT RequirementsBattery Life Physical DimensionsOM-550 DOS Software Table of Contents Introduction How to Use This ManualFonts Used in this Manual Printer CPU, RAM, Hardware∙ Hard Drive Installation Software InstallationTo start the program Starting the ProgramMaster Menu Reading Data from the OM-550 To load a LOG file Load Existing LOG FilesModify Software Configuration U6u To list data List Data on MonitorTo save data as text Print Data on PrinterSave Text File To print dataTo edit a plot label Edit Plot LabelsHOT Plot Status BAR To Magnify a portion of the Data Graph Magnify ToolMagnify MAP Magnified Area Axis Labels To select a channel to graph Channel DataTo link plot lines Channels 4 & 5 After Linking Data Graph ∙ X-Data Cursors ∙ Data Plots∙ X-Cursor Data Table To activate the Help menu Help MenuTo list log files List Existing LOG Files on PrinterTo quit Appendix a KEY Functions