NETGEAR SC101 manual Hard Disk Problems and Drive Errors, Hard Disk Problem Action

Hard Disk Problems and Drive Errors

The table below describes hard disk problems and drive errors.

Hard Disk Problem	Action
Hard disk does not work	1. See SC101 Hard Drive Compatibility.
	Older disk drives do not work in the SC101. The
	green power LED flashes 4 times after power on.
	2. SC101 hard disk format is required.
	The SC101 hard disk data format is different from a PC
	hard disk. To move a PC hard disk to the SC101, back
	up the data, reformat the drive for the SC101, and then
	copy the data onto the hard drive.
	1. Configure the hard disk as Cable Select.
	To do this, power off the SC101, change the disk
	setting to “Cable Select," and then repower.
	For information about computer hard disk Interfaces,
	and types of ATA, click here.
Errors: “Unable to enumerate drive”,	This is a Windows issue. Even though the drive is
and drive letter cannot be added	already mapped, Windows returns whatever letter it
	thinks is the next highest.
	1. Use Windows Explorer to see if a letter drive is
	mapped to a shared network folder or network drive.
	These mapped drives are not properly recognized by
	Windows.
	2. To fix this, re-map the drives with a letter toward the
	end of the alphabet, such as Z. Then work your way in
	reverse, (Y, X, W...).
	3. Then detach and re-attach the SC101 partition. It
	should get the drive letter without problem.
Unusable drive	You can use the DOS utility ut.exe from the Command
	Line Interface to remove a disk drive. See the CLI
If a drive was not successfully created,	section of this document for instructions.
an unusable drive may appear in the
GUI. If this happens, remove the drive.

13