NETGEAR SC101 manual Error Drive attachment failed when Attach Partition Fails, Symptom

Page 19

Error "Drive attachment failed" when Attach Partition Fails

Symptom

While using the SCM utility to attach a new partition, the error "Drive attachment failed" displays in the Status line (as shown).

Cause

The SC101 partition information is corrupted. This can happen if:

1.You disconnect a hard drive while the SC101 is powered on.

2.You move a hard drive from one SC101 to another SC101.

3.The hard disk has a hardware failure.

Solution

Use the CLI to view the corrupted characters with the ut_full_getpart . (See the CLI Reference (need link)

19

Image 19

Contents Netgear SC101 Revised Troubleshooting Guide Page Troubleshooting Tips Viewing and Accessing DrivesWindows Disk Management Unallocated Partitions Page Page Page Cannot See Partition Old Firmware Problem Click Attach Drive If a partition has never been seen on a particular computerPrerequisites Cannot Create a MirrorIii. Click Attach Drive Check LED Lights URL Link Light Light State What It Means What You Should Do LED IndicatorsHardware Link or FritzBox RoutersDefragmenting LAN ConnectionHard Disk Problem Action Hard Disk Problems and Drive ErrorsSCM Software SCM InstallationSolution To customize font settingsError Message Meaning and Action Error Messages No Central Storage Action Device was Found No Central Storage Device was Found in SmartWizardNo Central Storage Device was Found Action Symptoms SmartSync Pro Activation ErrorCause Symptom Error Drive attachment failed when Attach Partition FailsSystem Requirements About the SC101Heat and the SC101 How does heat affect the Storage Central performance? SC101 PerformanceNew Technology File System Ntfs Self-certifying File System SFSSAN and Network Attached Storage NAS Type ut listall, then Enter SC101 Command Line Interface CLI for Advanced UsersUsing CLI Commands Type cd c\Program Files\NETGEAR\SC101Unique Name Fixing Corrupted Characters Command utfull getpart00 00 00 00 00 00 00 00 01 00 01 00 00 00 0A 00 00 00 00 00 00 00 00 02 00 02 00 00 00 0AType sc config ftsata2 start= disabled To disable the Promise drivers and install the SCM UtilityType cd C\Program Files\NETGEAR\SC101 Manager Utility Data recovery with SFSExtract.exeRemoving an Unusable Drive with ut.exe To remove an unusable drive from the SC101Type SFSExtract Single drive target

Related manuals

Manual 2 pages 44.73 Kb

Manual 54 pages 17.75 Kb