NETGEAR WMS105-10000S user manual To configure Radius Server Settings

Page 23

ProSafe 5 AP Wireless Management Software WMS105

Radius Server Settings

If you are using a Radius server in your network for authentication, you must configure Radius settings. You can configure four types of servers:

•Primary Authentication Server: The main Radius server used for authentication.

•Secondary Authentication Server: A Secondary Authentication Server can be configured for use if the Primary Authentication Server fails or is unreachable.

•Primary Accounting Server: This server is used for accounting on the network.

•Secondary Accounting Server: A Secondary Accounting Server can be configured to use if the Primary Authentication Server fails or is unreachable.

To configure Radius Server Settings:

1.Click the Configuration tab and select Security > Basic > Radius Server Settings:

The primary server is used by default. If it fails, the secondary server is used, if configured.

2.Fill in the IP Address, Port, and Shared Secret fields for each Radius server.

•The IP Address, Port, and Shared Secret information is required to communicate with the Radius server.

•The Shared Secret is shared between the wireless access point and the Radius server while authenticating the wireless client.

3.Enter the Authentication Settings.

•Re-authentication Time (Seconds): This is the time interval in seconds after which the supplicant will be authenticated again with the RADIUS server. The default interval is 3600 seconds.

•Update Global Key Every (Seconds): Enable this option to have the Global Key changed according to the time interval specified. If enabled, enter the desired time interval. The default is enable, and the default interval is 1800 Seconds.

4.Click Apply so that your changes take effect.

Chapter 4: Security Configuration 23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents ProSafe 5 AP Wireless Management Software WMS105 Technical Support NETGEAR, Inc Table of Contents Index Getting Started Installing the SoftwareLogging System SettingsGeneral Settings Time Settings Syslog Settings Auto Discovery Access Point DiscoveryTo use Auto Discovery IP DiscoveryTo use IP Discovery Discovery ResultsAdding Access Points Configuring Centralized RF Management Wireless ConfigurationProSafe 5 AP Wireless Management Software WMS105 To manually specify the Wlan parameters for access points Advanced Wireless SettingsSend packet before sending the actual packet data To specify QoS settings Configuring QoSQoS for Managed Access Points To view or change security profiles Security ConfigurationSecurity Profiles List Editing a Security Profile Network Authentication and Data Encryption Rogue Access PointsMAC Authentication To set up MAC Authentication To configure Radius Server Settings Radius Server SettingsTo set up guest access Configuring Guest AccessSummary Access Point SummaryMonitoring Access Point Status Wireless StationsProfile Information Access Point Status DetailsClient Status Monitoring Rogue Access PointsProSafe 5 AP Wireless Management Software WMS105 To change the password MaintenanceChanging Passwords Snmp ResetRemote Management Upgrading Access Point FirmwareTo upgrade the access point software To restore settings from a backup file Backing up Configuration SettingsRestoring Settings from a File To back up the Wireless Management Software settingsTo download logs Downloading Wireless Management Software LogsTo change the settings Using Discovery OUIAccess Point Supported Firmware Versions Access Point CompatibilitySSH Software Features and Access Point CompatibilityIndex Index
Top Page Image Contents