NETGEAR DG814 DSL Connecting the Power Adapter, Verifying Power, Adsl through other wall jacks

Reference Manual for the Model DG814 DSL Modem Internet Gateway

ADSL through other wall jacks

1.Plug the “LINE” connection from the included microfilter into the wall jack.

2.Connect the “DSL” jack of the microfilter to the ADSL port of your gateway using the telephone cable provided.

3.Connect the “PHONE” side of the microfilter to your telephone, using your existing telephone cable.

A telephone can be attached to the second RJ-11 jack on your gateway. However, a microfilter should be connected between the gateway and the telephone. Be careful to connect the microfilter according to its markings, with the “LINE” side plugged into the gateway and the “PHONE” side connected to your telephone.

If you have additional telephones, you will need to purchase additional microfilters and connect them between the telephones and the wall jack. A microfilter is required for each telephone on the line.

Note: Microfilters are required to isolate your ADSL signal from your telephone signal. If microfilters are not used, or if they are connected backward, you may notice a “ticking” noise on your telephone, and the performance of your ADSL line may be affected.

Connecting the Power Adapter

To connect the power adapter to the gateway:

1.Plug the connector of the power adapter into the 18 V AC adapter outlet on the rear panel of the gateway.

2.Plug the other end of the adapter into a standard wall outlet.

3.Set the gateway’s Power switch to the ON position.

4.Verify that the PWR LED on the gateway is lit.

Verifying Power

After applying power to the gateway, complete the following steps to verify that power is correctly applied:

1.When power is first applied, verify that the Power LED comes on.

Setting Up the Hardware 2-7