NETGEAR DG814 DSL manual Obtaining a WAN IP Address, WAN LED Off

Page 84

Reference Manual for the Model DG814 DSL Modem Internet Gateway

If the WAN LED does not turn green, disconnect all telephones on the line. If this solves the problem, reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the microfilters are connected correctly, you should be able to connect all your telephones.

If disconnecting telephones does not result in a green WAN LED there may be a problem with your wiring. If the telephone company has tested the ADSL signal at your Network Interface Device (NID), then you may have poor quality wiring in your house.

WAN LED Off

If the WAN LED is off, disconnect all telephones on the line. If this solves the problem, reconnect the telephones one at a time, being careful to use a microfilter on each telephone. If the microfilters are connected correctly, you should be able to connect all your telephones.

If disconnecting telephones does not result in a green WAN LED the problem may be one of the following:

Check that the telephone company has made the connection to your line and tested it.

Verify that you are connected to the correct telephone line. If you have more than one phone line, be sure that you are connected to the line with the ADSL service. It may be necessary to use a swapper if you ADSL signal is on pins 1 and 4 or the RJ-11 jack. The Model DG814 gateway uses pins 2 and 3.

Obtaining a WAN IP Address

If your gateway is unable to access the internet, and your WAN LED is green or blinking green, you should determine whether the gateway is able to obtain a WAN IP address from the ISP. Unless you have been assigned a static IP address, your gateway must request an IP address from the ISP. You can determine whether the request was successful using the browser interface.

To check the WAN IP address from the browser interface:

1.Launch your browser and select an external site such as www.netgear.com

2.Access the Main Menu of the gateway’s configuration at http://192.168.0.1

3.Under the Maintenance heading check that an IP address is shown for the WAN Port If 0.0.0.0 is shown, your gateway has not obtained an IP address from your ISP.

If your gateway is unable to obtain an IP address from the ISP, the problem may be one of the following:

8-4

Troubleshooting

Image 84
Contents NETGEAR, Inc Trademarks World Wide Web Page Contents Chapter Preparing Your Network Chapter Maintenance Appendix a Technical Specifications Figure B-1 Page Table B-1 Xii About This Guide Technical Support Related PublicationsXiv About This Guide Typographical Conventions Special Message FormatsPage Key Features Chapter IntroductionAbout the Gateway Introduction Content Filtering SecurityAutosensing 10/100 Ethernet Easy Installation and Management TCP/IPMaintenance and Support Introduction Chapter Setting Up the Hardware Package ContentsAccess Requirement Local Network Hardware RequirementsGateway’s Front Panel PC RequirementsGateway’s Rear Panel LED DescriptionsConnecting the Gateway Connecting to your Local Ethernet Network Typical installationConnecting to Your Adsl Service and Telephone Provider Adsl through a modular RJ-11 wall jackConnecting the Power Adapter Verifying PowerAdsl through other wall jacks Setting Up the Hardware Chapter Preparing Your Network Preparing Your Personal Computers for IP NetworkingConfiguring Windows 95, 98, and ME for IP Networking Install or Verify Windows Networking ComponentsPreparing Your Network Assign TCP/IP configuration by Dhcp Selecting Internet Access MethodConfiguring Windows NT or 2000 for IP Networking Verifying TCP/IP Properties WindowsConfiguring the Macintosh for IP Networking Verifying TCP/IP PropertiesMacOS 8.6 or MacOS Your Internet Account Verifying TCP/IP Properties MacintoshLogin Protocols Account InformationObtaining ISP Configuration Information Windows Ready for Configuration Obtaining ISP Configuration Information MacintoshRestarting the Network Preparing Your Network Chapter Basic Configuration of the Gateway Accessing the Web Configuration ManagerLogin window opens as shown in -1below Browser-based configuration main menu Configuration using the Setup Wizard Configuring for Dynamic IP Account Setup Wizard menu for Dynamic IP addressConfiguring for Fixed IP Account Setup Wizard menu for Fixed IP addressConfiguring for an Account with Login Setup Wizard menu for PPPoE login accountsManual Configuration Completing the Configuration Basic Configuration of the Gateway Chapter Content Filtering Configuring for Content FilteringLogs Block Sites Schedule Mail Content Filtering Chapter Maintenance Gateway StatusThis screen shows the following parameters Dhcp This screen shows the following statistics PPPoE Status screen Attached Devices Ping Status screenConfiguration File Settings Management Restore and Backup the ConfigurationChanging the Configuration Password Erase the ConfigurationGateway Upgrade Gateway Upgrade menuMaintenance Advanced Configuration of the Gateway Configuring for Port Forwarding to Local ServersAdd a Custom Service Edit or Delete a Port Forwarding Entry Local Web and FTP Server ExampleTip Multiple Computers for Half Life, Kali or Quake NAT Status Security DMZ ServerDynamic DNS Respond to Ping on Internet WAN PortLAN IP Setup LAN IP Setup MenuLAN TCP/IP Setup Use router as Dhcp serverStatic Routes Static Route Summary Table Static Route Example Advanced Configuration of the Gateway Chapter Troubleshooting Basic FunctioningPWR LED Not On Troubleshooting the Web Configuration Interface Test LED Never Blinks or LED Stays OnTroubleshooting the ISP Connection Adsl linkWAN LED Green or Blinking Green WAN LED Blinking YellowObtaining a WAN IP Address WAN LED OffTroubleshooting PPPoE or PPPoA Troubleshooting Internet BrowsingTroubleshooting a TCP/IP Network Using a Ping Utility Testing the LAN Path to Your GatewayTesting the Path from Your PC to a Remote Device Ping -n 10 IP addressRestoring the Default Configuration and Password Problems with Date and TimeUsing the Default Reset button Appendix a Technical Specifications General SpecificationsLAN What is a Router? Appendix B Networks and Routing BasicsBasic Router Concepts Routing Information Protocol IP Addresses and the InternetClass E Class E addresses are for experimental use Netmask Subnet AddressingFigure B-2. Example of Subnetting a Class B Address Table B-1. Netmask Notation Translation Table for One Octet Single IP Address Operation Using NAT Private IP AddressesFigure B-3. Single IP Address Operation Using NAT MAC Addresses and Address Resolution Protocol Domain Name ServerIP Configuration by Dhcp Uplink Switches, Crossover Cables, and MDI/MDIX Switching Ethernet CablingCable Quality Glossary For example Internet Through the network Auto MDI/MDI-X1-4, 2-6, B-11, B-12 DMZ 1-3, 5-2 MDI/MDI-X1-4, 2-6, B-11, B-12 NTP 5-6 Xiii, B-7 1631 xiv, B-8