Nlynx ZWA-G120 user manual

Page 22

9.Wait for refreshing web page.

10.Change the IP address of your PC to 192.168.3.x then access the web server by the new IP address “192.168.3.1” and use “Status” page check the setting.

11.If the “State” of “Wireless Configuration” is not “Connected” or you want to refresh the “RSSI “, please use “Site Survey” page to re-connect a AP.

20

Image 22

Contents Wireless LAN Device Series Version .0.0Table of Contents Preface CH 1. ZWA-G120 Installation Preface Hardware Installation Packing ListBefore Start to Configure Knowing the Network ApplicationWDS+AP Wisp Examples of Configuration Page Page Page Page Page Page Page Page Page Page Use the Status page to check the settings Page Page Page Page Page Page Page Band Disable Wireless LAN InterfaceMode Ad Hoc Channel NumberAssociated Client Fragment Threshold Advanced SettingsAuthentication Type RTS ThresholdBroadcast Ssid Data RateBeacon Interval Int. RoamingTransmit Power Block Wlan Relay Isolate ClientConfiguring Wireless Security WEP Encryption SettingWEP Encryption with 802.1x Setting Enterprise Radius WPA Encryption SettingWPA Authentication Mode Pre-Share KeyConfiguring as Wlan Client Adapter Quick start to configurePage Authentication Type Data EncryptionWDS network topology Bus topologyStar topology Ring topologyWDS Application Wireless RepeaterMesh topology： Wireless Bridge Wireless stationPort Filtering Configuring LAN to WAN FirewallIP Filtering Configuring Port Forwarding Virtual Server MAC FilteringConfiguring DMZ Multiple Servers behind NAT ExampleConfiguring WAN Interface Static IP IP AddressDhcp Client Dynamic IP PPPoEPptp Configuring Clone MAC Address MTU SizePage Configuring Dhcp Server Using CLI Menu System ManagementFirmware Upgrade About Snmp AgentConfiguration Data Backup & Restore