Nlynx ZWA-G120 user manual Authentication Type, Data Encryption

Page 38

Note

If the available network requires authentication and data encryption, you need to setup the authentication and encryption before step1 and all the settings must be as same as the Access Point or Station. About the detail authentication and data encryption settings, please refer the security section.

Authentication Type

In client mode, the device also supports two Authentication Types “Open system” and “Shared Key”. Although the default setting is “Auto”, not every Access Points can support “Auto” mode. If the authentication type on the Access Point is knew by user, we suggest to set the authentication type as same as the Access Point.

Data Encryption

In client mode, the device supports WEP and WPA Personal/Enterprise except WPA2 mixed mode data encryption. About the detail data encryption settings, please refer the security section.

36

Image 38
Contents Wireless LAN Device Series Version .0.0Table of Contents Preface CH 1. ZWA-G120 Installation Preface Hardware Installation Packing ListBefore Start to Configure Knowing the Network ApplicationWDS+AP Wisp Examples of Configuration Page Page Page Page Page Page Page Page Page Page Use the Status page to check the settings Page Page Page Page Page Page Page Mode Disable Wireless LAN InterfaceBand Ad Hoc Channel NumberAssociated Client Fragment Threshold Advanced SettingsAuthentication Type RTS ThresholdBroadcast Ssid Data RateBeacon Interval Int. RoamingTransmit Power Block Wlan Relay Isolate ClientConfiguring Wireless Security WEP Encryption SettingWEP Encryption with 802.1x Setting Enterprise Radius WPA Encryption SettingWPA Authentication Mode Pre-Share KeyConfiguring as Wlan Client Adapter Quick start to configurePage Authentication Type Data EncryptionWDS network topology Bus topologyStar topology Ring topologyMesh topology: Wireless RepeaterWDS Application Wireless Bridge Wireless stationIP Filtering Configuring LAN to WAN FirewallPort Filtering Configuring Port Forwarding Virtual Server MAC FilteringConfiguring DMZ Multiple Servers behind NAT ExampleConfiguring WAN Interface Static IP IP AddressDhcp Client Dynamic IP PPPoEPptp Configuring Clone MAC Address MTU SizePage Configuring Dhcp Server Using CLI Menu System ManagementFirmware Upgrade About Snmp AgentConfiguration Data Backup & Restore