Nlynx ZWA-G120 user manual Wireless Bridge, Wireless station

Page 42

Ethernet

Wireless station

APRepeater

Description

Entries of WDS AP List

Spanning Tree

Protocol Required

 

 

Access Point

The MAC Address of Repeater

Yes

Repeater

The MAC Address of Access Point

Yes

Wireless Bridge

Wireless Bridge can establish a wireless connection between two or more Wired LANs. When you decide to use the WDS as a Wireless Bridge, please refer the following instructions for configuration.

zIn AP mode, enable the WDS function.

zYou must set these connected devices with the same radio channel, but you may use different SSID.

zChoose “WDS” mode for only wireless backbone extension purpose.

zYou can use any network topology, please refer the WDS topology section.

40

Image 42
Contents Wireless LAN Device Series Version .0.0Table of Contents Preface CH 1. ZWA-G120 Installation Preface Hardware Installation Packing ListBefore Start to Configure Knowing the Network ApplicationWDS+AP Wisp Examples of Configuration Page Page Page Page Page Page Page Page Page Page Use the Status page to check the settings Page Page Page Page Page Page Page Disable Wireless LAN Interface BandMode Ad Hoc Channel NumberAssociated Client Fragment Threshold Advanced SettingsAuthentication Type RTS ThresholdBroadcast Ssid Data RateBeacon Interval Int. RoamingTransmit Power Block Wlan Relay Isolate ClientConfiguring Wireless Security WEP Encryption SettingWEP Encryption with 802.1x Setting Enterprise Radius WPA Encryption SettingWPA Authentication Mode Pre-Share KeyConfiguring as Wlan Client Adapter Quick start to configurePage Authentication Type Data EncryptionWDS network topology Bus topologyStar topology Ring topologyWireless Repeater WDS ApplicationMesh topology: Wireless Bridge Wireless stationConfiguring LAN to WAN Firewall Port FilteringIP Filtering Configuring Port Forwarding Virtual Server MAC FilteringConfiguring DMZ Multiple Servers behind NAT ExampleConfiguring WAN Interface Static IP IP AddressDhcp Client Dynamic IP PPPoEPptp Configuring Clone MAC Address MTU SizePage Configuring Dhcp Server Using CLI Menu System ManagementFirmware Upgrade About Snmp AgentConfiguration Data Backup & Restore