Nlynx ZWA-G120 user manual

Page 24

5.Press “Next>>” button then set the IP address of LAN interface.

6.Press “Next>>” button then select the “Client” for “mode” and change the SSID to “ZPlus-G120-DEV5”.

7.Press “Next>>” button then select “None” for “Encryption” then press “Finished” button.

8.Wait for refreshing web page.

22

Image 24

Contents Wireless LAN Device Series Version .0.0Table of Contents Preface CH 1. ZWA-G120 Installation Preface Hardware Installation Packing ListBefore Start to Configure Knowing the Network ApplicationWDS+AP Wisp Examples of Configuration Page Page Page Page Page Page Page Page Page Page Use the Status page to check the settings Page Page Page Page Page Page Page Disable Wireless LAN Interface BandMode Ad Hoc Channel NumberAssociated Client Advanced Settings Authentication TypeFragment Threshold RTS ThresholdData Rate Beacon IntervalBroadcast Ssid Int. RoamingTransmit Power Block Wlan Relay Isolate ClientConfiguring Wireless Security WEP Encryption SettingWEP Encryption with 802.1x Setting WPA Encryption Setting WPA Authentication ModeEnterprise Radius Pre-Share KeyConfiguring as Wlan Client Adapter Quick start to configurePage Authentication Type Data EncryptionWDS network topology Bus topologyStar topology Ring topologyWireless Repeater WDS ApplicationMesh topology： Wireless Bridge Wireless stationConfiguring LAN to WAN Firewall Port FilteringIP Filtering Configuring Port Forwarding Virtual Server MAC FilteringConfiguring DMZ Multiple Servers behind NAT ExampleConfiguring WAN Interface Static IP IP AddressDhcp Client Dynamic IP PPPoEPptp Configuring Clone MAC Address MTU SizePage Configuring Dhcp Server Using CLI Menu System ManagementFirmware Upgrade About Snmp AgentConfiguration Data Backup & Restore