Nlynx ZWA-G120 user manual Configuring Dhcp Server

Page 52

4.Clone MAC address for PPTP WAN access type

5.Physical LAN interface MAC address clone

Configuring DHCP Server

1.To use the DHCP server inside the device, please make sure there is no other DHCP server existed in the same network as the device.

2.Enable the DHCP Server option and assign the client range of IP addresses as following page.

3.When the DHCP server is enabled and also the device router mode is enabled

50

Image 52

Contents Wireless LAN Device Series Version .0.0Table of Contents Preface CH 1. ZWA-G120 Installation Preface Hardware Installation Packing ListBefore Start to Configure Knowing the Network ApplicationWDS+AP Wisp Examples of Configuration Page Page Page Page Page Page Page Page Page Page Use the Status page to check the settings Page Page Page Page Page Page Page Band Disable Wireless LAN InterfaceMode Ad Hoc Channel NumberAssociated Client Advanced Settings Authentication TypeFragment Threshold RTS ThresholdData Rate Beacon IntervalBroadcast Ssid Int. RoamingTransmit Power Block Wlan Relay Isolate ClientConfiguring Wireless Security WEP Encryption SettingWEP Encryption with 802.1x Setting WPA Encryption Setting WPA Authentication ModeEnterprise Radius Pre-Share KeyConfiguring as Wlan Client Adapter Quick start to configurePage Authentication Type Data EncryptionWDS network topology Bus topologyStar topology Ring topologyWDS Application Wireless RepeaterMesh topology： Wireless Bridge Wireless stationPort Filtering Configuring LAN to WAN FirewallIP Filtering Configuring Port Forwarding Virtual Server MAC FilteringConfiguring DMZ Multiple Servers behind NAT ExampleConfiguring WAN Interface Static IP IP AddressDhcp Client Dynamic IP PPPoEPptp Configuring Clone MAC Address MTU SizePage Configuring Dhcp Server Using CLI Menu System ManagementFirmware Upgrade About Snmp AgentConfiguration Data Backup & Restore