Minicom Advanced Systems CMG-DCM manual

Page 23

Operator's guide

Slide the disk out and replace with another Lacie U&I drive, or any brand of IDE / USB or IEEE 1394 2.5” drive you specify (at the time of manufacture). You can do this at any time without losing data.

7.Plug the hard disk into any computer that supports the USB Mass Storage standard using a standard USB cable. Newer Linux distributions and Microsoft Windows XP have this enabled by default.

In Windows XP, you should see a series of Found new hardware messages indicating that the drive has been recognised. A new disk drive icon should appear in My Computer:

This process may take several minutes to complete.

December 2005

23

Image 23

Contents CMG-DCM Table of Contents December Inside the DCM Introduction CMG-DCM Inside the DCM Network services Serial port servicesSee .4, Connecting to a local network for full details Overview Installing the CMG-DCMPower supply Connecting over a serial link Connecting to a single computer192.168.0.x Connecting over EthernetConnecting over USB Using an internal modemConnecting to a local network Gcfgdbset option-namenew-value Connecting to the Internet Wi-FiSetting up the CMG-DCM Connecting digitizers and external hardwareWeb setup Setting up digitizers Using Scream DCM as a data store UsageGeneral notes Gnblocks port-number Page CMG-DCM DCM as a GCF data source Accessing the DCM command line through gcfout Sensor arrays DCM as a network data hub Communicating with digitizers Configuring digitizers Data storage and retrieval Using miniSEED format Real-time data transmission CD1.0 and CD1.1 Troubleshooting DCM installations Cannot Gcfping the DCMs Scream! server Cannot see the DCMs Web site over Http or HttpsCannot connect to the DCMs Scream! server DCM is not receiving any data streams Can Gcfping the DCMs Scream! server, but no data appearsDCM is receiving streams, but they do not contain any data Use the Serial port configuration → port name Web page, or143032 up 34 min, load average 1.24, 1.32 General Configuration optionsDisk CMG-DCM Serial port configuration CMG-DCM Page Ethernet port Network configurationStatic routes DNS setup Incoming mail setup Outgoing mail setup Remote access Administrators PPP Mgetty Scream Data transferAutoDRM Scream! ClientCD1.0 Http serverHttp client CD1.1 CD1.1 subframe configuration DSS Server configuration Seed Page CMG-DCM Data Viewer ActionsStream list Icon barDigitizer Setup General digitizer settings Digitizer output control CMG-DCM Trigger criteria CMG-DCM Tap # Rate Bandwidth Samples/s Auxiliary Mux channels Sensor mass control Flush flash Disk toolsPartition, and format disk Check disk filesystemRecent Log Entries Disk filesCamera Summary Network configurationData Out Port, Serial Port A, Serial Port B DNS configurationDisk Status Flash StatusTamper lines Software Versions Inside the DCM File systems CMG-DCM Command line tools Configuration Digitizer console access Data flow MonitoringDigitizer status Tamper lines Removing support packages Updating the DCMOver the Internet From the hard diskFirmware Libgconfigdb Data OUT port Appendix a Connector pinoutsAppendix A.1 Modular DCM units Port a and BNetwork connector USB connectorDM/AM module output Appendix A.2 Integrated DCM unitsAppendix B.1 Sensor response codes Appendix B Sensor and digitizer typesDigitizer Appendix B.2 Digitizer type codes