Minicom Advanced Systems CMG-DCM manual Actions, Data Viewer

Page 65

Operator's guide

5 Actions

5.1 Data Viewer

The Data viewer page uses a simple Java applet to enable you to check that the DCM is receiving data correctly. Your browser must have Java installed for you to be able to do this.

The data viewer is not intended to be a fully functional data visualisation tool. Scream! and similar software packages offer a full range of facilities for displaying and manipulating seismic data, either as it arrives or from stored data files.

The main part of the display shows a selection of the data streams being recorded, whilst the bars at the top and bottom allow you to control what is displayed, and in what manner:

If you cannot see any data in the Data Viewer, you should check first that

some streams have been checked in the lower portion of the applet, and

the data has been offset correctly. You can automatically zero the streams by clicking on the icon depicting a “0” and a sine wave in the icon bar. Otherwise, you can zoom out until the streams are visible.

December 2005

65

Image 65
Contents CMG-DCM Table of Contents December Inside the DCM Introduction CMG-DCM Inside the DCM Network services Serial port servicesSee .4, Connecting to a local network for full details Overview Installing the CMG-DCMPower supply Connecting over a serial link Connecting to a single computer192.168.0.x Connecting over EthernetConnecting over USB Using an internal modemConnecting to a local network Gcfgdbset option-namenew-value Connecting to the Internet Wi-FiSetting up the CMG-DCM Connecting digitizers and external hardwareWeb setup Setting up digitizers Using Scream DCM as a data store UsageGeneral notes Gnblocks port-number Page CMG-DCM DCM as a GCF data source Accessing the DCM command line through gcfout Sensor arrays DCM as a network data hub Communicating with digitizers Configuring digitizers Data storage and retrieval Using miniSEED format Real-time data transmission CD1.0 and CD1.1 Troubleshooting DCM installations Cannot Gcfping the DCMs Scream! server Cannot see the DCMs Web site over Http or HttpsCannot connect to the DCMs Scream! server DCM is not receiving any data streams Can Gcfping the DCMs Scream! server, but no data appearsDCM is receiving streams, but they do not contain any data Use the Serial port configuration → port name Web page, or143032 up 34 min, load average 1.24, 1.32 General Configuration optionsDisk CMG-DCM Serial port configuration CMG-DCM Page Ethernet port Network configurationStatic routes DNS setup Incoming mail setup Outgoing mail setup Remote access Administrators PPP Mgetty Scream Data transferAutoDRM Scream! ClientCD1.0 Http serverHttp client CD1.1 CD1.1 subframe configuration DSS Server configuration Seed Page CMG-DCM Data Viewer ActionsStream list Icon barDigitizer Setup General digitizer settings Digitizer output control CMG-DCM Trigger criteria CMG-DCM Tap # Rate Bandwidth Samples/s Auxiliary Mux channels Sensor mass control Partition, and format disk Disk toolsCheck disk filesystem Flush flashRecent Log Entries Disk filesCamera Summary Network configurationData Out Port, Serial Port A, Serial Port B DNS configurationDisk Status Flash StatusTamper lines Software Versions Inside the DCM File systems CMG-DCM Command line tools Configuration Digitizer console access Data flow MonitoringDigitizer status Tamper lines Over the Internet Updating the DCMFrom the hard disk Removing support packagesFirmware Libgconfigdb Appendix A.1 Modular DCM units Appendix a Connector pinoutsPort a and B Data OUT portNetwork connector USB connectorDM/AM module output Appendix A.2 Integrated DCM unitsAppendix B.1 Sensor response codes Appendix B Sensor and digitizer typesDigitizer Appendix B.2 Digitizer type codes