Multi-Tech Systems FR111 owner manual DIP-Switch Settings

3.4Setup

Use the following steps to setup your MultiFRAD. If V.35 electrical interface signaling is required on the data port, but a pc with EIA-232D signaling is being used to configure the MultiFRAD, the unit has to be configured before you change to V.35 signaling. Perform the following procedure to connect your cables, configure the unit, and then change to V.35 signaling on the data port.

1.Ensure that the DIP-Switch settings on the side of the unit are set for a command mode of operation. Refer to the Switch Settings in Chapter 2.

DIP-Switches

Figure 3-1. DIP-Switch Settings

2.Connect the external wall transformer power supply to the Multi- FRAD and plug it into a live AC outlet. The MultiFRAD does not have a power switch. When power is applied to the unit, the front panel LEDs will light.

Power Data Trunk

Figure 3-2. Power Connection

3.Connect a pc running Windows® to theData connector on the back of the MultiFRAD. Use an appropriate EIA-232D cable. Refer to Appendix A for EIA-232D cable details.

Power Data Trunk

PC Serial Cable

Figure 3-3. Data Connection

32