MaxTech 800, 28 Section Eight Support and Service, Section Nine FCC , DOC & Other Notices

Page 18

Section Seven

- Specifications

Communication Std. V.34, V.FC, V.32bis, V.32, V.29, V.27ter,

 

V.22bis, V.23, V.22, V.21, V.17, Bell212/

 

103

Data Compression:

V.42bis/MNP5

Error Correction:

V.42/MNP2-4

Host Interface:

8 bit PC bus

COM ports:

1, 2, 3, 4

IRQ lines:

2, 3, 4, 5

FAX Group:

Group III Send/Receive Standard

FAX Command set: EIA/TIA-578 Service Class 1, EIA/TIA-

 

SP2388 Service Class 2

Transmit level:

-12 dBm +/- 1 dB

Receiver Sensitivity: -43 dBm

UART:

16550 compatible

Data format:

300-115200 bps

Power:

2.5 W

Temperature:

0 to 55 degrees C (Operating)

Section Eight - Support and Service

In the unlikely event you experience difficulty in the use of this product, we suggest you: (1) consult the Troubleshooting section of this guide and (2) consult with your dealer. To obtain service for this product, follow the Return Merchandise Authorization Proce- dure as outlined in the Warranty card.

Section Nine - FCC , DOC & Other Notices

9.1 FCC Compliance

This equipment complies with Part 68 of the FCC Rules. On this equipment is a label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this informa- tion to your telephone company.

If your telephone equipment causes harm to the telephone net- work, the Telephone Company may discontinue your service temporarily. If possible, they will notify in advance. But, if advance notice isn’t practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Your telephone company may make changes in its facilities, equipment, operations, or procedures that could affect proper

17

Image 18
Contents MAN018 Rev Section One Introduction Section Two InstallationHardware Installation Unpacking Your ModemCommon Serial Ports Male connector Software Installation/ConfigurationCOM Port and Interrupt Settings SW1 Settings Devices in your computer cannot share an IRQ withUsing Your Modem Using the Fax Capabilities of the ModemTesting Your Modem After Installation Where To Go From HereBasic AT Commands Executing CommandsCommand Structure Bold text Command FunctionTouch-tone dialing Commands are echoedLow speaker volume DS=nExtended AT Commands Disable originate-only mode Guard tone disabledModem is set up for dial-up line operation US setting for off-hook-to-on-hook ratioMNP/V.42/V.42bis Commands Section Four S Registers S Registers Function Range/units Default Section Five Result CodesExtended Response Codes Connect 19200/V42BIS Modem does not dial Section Six TroubleshootingModem does not respond to commands Modem dials but does not connectModem makes a connection but no data appears on your screen 42bis/V.42/MNP2-5 does not workHigh pitch tone is heard whenever you answer the phone Section Eight Support and Service Section Nine FCC , DOC & Other NoticesFCC Compliance FCC Class B Statement DOC Compliance InformationDisclaimer, Copyright, And Other Notices