MaxTech 28, 800 user manual Common Serial Ports Male connector, Software Installation/Configuration

Page 3
Figure 2-2
Expansion
Slots

Figure 2-1 Common Serial Ports

male connector

set to COM1 on IRQ4. Reconfigure the modem to either COM3/IRQ5 or COM4/IRQ2 (refer to Table 2-1 in Sec- tion 2.4).

4.Remove your computer's cover (refer to your computer's owner manual).

5. Select any available half-card slot, and then remove the slot cover (refer to Figure 2-2).

6.Carefullyslidetheinternalmo- dem into the slot you have chosen, applying even pres- sure until the modem is com- pletely seated in the slot.

7.Fasten the retaining bracket with the screw from the slot cover. Make sure the modem is properly aligned. Store the slot cover for future use.

8.Replace the computer cover and plug in your computer.

9.Connect the telephone cable from the modem (“LINE” connector) to the telephone wall jack.

10.Optionally, connect your telephone to the modem's “PHONE” connector.

11.Turn your computer on. Your modem is now installed.

2.3 Software Installation/Configuration

You are now ready to install and configure the commu- nication software. Refer to your software manual for instal- lation procedures. Your software must be configured to communicate with the modem on the same COM port and IRQ line used by the modem.

If you are using Microsoft Windows 3.x and have changed the modem's operating setting from the default COM1/ IRQ4 to COM3/IRQ5 or COM4/IRQ2 to avoid a conflict, you must use Windows' Control Panel (in the “Main” Group within Program Manager) to configure Windows to recognize the new settings before installing any software. In Control

2

Page 2 Page 4
Image 3
Page 2 Page 4
Contents MAN018 Rev Unpacking Your Modem Section Two InstallationHardware Installation Section One IntroductionSoftware Installation/Configuration Common Serial Ports Male connectorCOM Port and Interrupt Settings Devices in your computer cannot share an IRQ with SW1 SettingsWhere To Go From Here Using the Fax Capabilities of the ModemTesting Your Modem After Installation Using Your ModemBold text Command Function Executing CommandsCommand Structure Basic AT CommandsDS=n Commands are echoedLow speaker volume Touch-tone dialingExtended AT Commands US setting for off-hook-to-on-hook ratio Guard tone disabledModem is set up for dial-up line operation Disable originate-only modeMNP/V.42/V.42bis Commands Section Four S Registers Section Five Result Codes S Registers Function Range/units DefaultExtended Response Codes Connect 19200/V42BIS Modem dials but does not connect Section Six TroubleshootingModem does not respond to commands Modem does not dialModem makes a connection but no data appears on your screen 42bis/V.42/MNP2-5 does not workHigh pitch tone is heard whenever you answer the phone Section Eight Support and Service Section Nine FCC , DOC & Other NoticesFCC Compliance DOC Compliance Information FCC Class B StatementDisclaimer, Copyright, And Other Notices
Top Page Image Contents