MaxTech 28, 800 user manual FCC Class B Statement, DOC Compliance Information

Page 19

operation of your equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service.

The FCC prohibits this equipment to be connected to party lines or coin-telephone service.

In the event that this equipment should fail to operate properly, disconnect the equipment from the phone line to determine if it is causing the problem. If the problem is with the equipment, discon- tinue use and contact your dealer or vendor.

The FCC also requires the transmitter of a FAX transmission be properly identified (per FCC Rules Part 68, Sec. 68.381 (c) (3)).

9.2 FCC Class B Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. How- ever, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be deter- mined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and the receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio / TV technician for help

Notice: 1) Shielded cables, if any, must be used in order to comply with the emission limits. 2) Any change or modification not expressly approved by the Grantee of the equipment authorization could void the user’s authority to operate the equipment.

9.3 DOC Compliance Information

NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.

18

Image 19
Contents MAN018 Rev Unpacking Your Modem Section Two InstallationHardware Installation Section One IntroductionSoftware Installation/Configuration Common Serial Ports Male connectorCOM Port and Interrupt Settings Devices in your computer cannot share an IRQ with SW1 SettingsWhere To Go From Here Using the Fax Capabilities of the ModemTesting Your Modem After Installation Using Your ModemBold text Command Function Executing CommandsCommand Structure Basic AT CommandsDS=n Commands are echoedLow speaker volume Touch-tone dialingExtended AT Commands US setting for off-hook-to-on-hook ratio Guard tone disabledModem is set up for dial-up line operation Disable originate-only modeMNP/V.42/V.42bis Commands Section Four S Registers Section Five Result Codes S Registers Function Range/units DefaultExtended Response Codes Connect 19200/V42BIS Modem dials but does not connect Section Six TroubleshootingModem does not respond to commands Modem does not dial42bis/V.42/MNP2-5 does not work Modem makes a connection but no data appears on your screenHigh pitch tone is heard whenever you answer the phone Section Nine FCC , DOC & Other Notices Section Eight Support and ServiceFCC Compliance DOC Compliance Information FCC Class B StatementDisclaimer, Copyright, And Other Notices