MaxTech 28, 800 user manual Section Five Result Codes, S Registers Function Range/units Default

Page 13

		Table 4-1 S - Registers
Register		Function	Range/units Default
S0	Auto-answer Ring		0-255/rings	0
S1	Ring counter		0-255/rings	0
S2	Escape code character		0-127/ASCII	43
S3	Carriage return character		0-127/ASCII	13
S4	Line feed character		0-127/ASCII	10
S5	Backspace character		0-32, 127/ASCII	8
S6	Dial tone wait time		2-255 /seconds	2
S7	Remote carrier wait time		1-255/seconds	50
S8	Comma pause time		0-255/seconds	2
S9	Carrier detect response time 1-255/0.1 second			6
S10	Carrier loss time		1-255/0.1second	14
S11	Touch-tone dialing speed		50-255/0.001 second 95
S12	Escape character guard time 0-255/0.02 second			50
S13	Reserved
S14	Echo, response, dialing,		Bit-mapped register	138
	originate/answer
S15	Reserved
S16	Modem tests		Bit-mapped register	0
S17	Reserved
S18	Length of modem tests		0-255 /seconds	0
S19-20Reserved
S21	CTS, DTR, DCD, DSR		Bit-mapped register	4
	and Long Space Disconnect
S22	Speaker and response		Bit-mapped register	117
S23	Remote Digital Loopback		Bit-mapped register	55
	Request, data rate, parity
S24	Sleep mode timer		0-255/ seconds	0
S25	DTR delay		0-255 /0.01 second	5
S26	RTS/CTS delay interval		0-255 /0.01 second	1
S27	Asynchronous/Bell		Bit-mapped register	73
	CCITT Modes
S28	Make/break ratio		Bit-mapped register	0

Section Five - Result Codes

BASIC RESPONSE CODES

OK	0	NO DIALTONE	6
CONNECT	1	BUSY	7
RING	2	NO ANSWER	8
NO CARRIER	3	CONNECT 2400	10
ERROR	4	CONNECT 4800	11
CONNECT 1200	5	CONNECT 7200	12

12

Image 13

Contents MAN018 Rev Hardware Installation Section Two InstallationSection One Introduction Unpacking Your ModemSoftware Installation/Configuration Common Serial Ports Male connectorCOM Port and Interrupt Settings Devices in your computer cannot share an IRQ with SW1 SettingsTesting Your Modem After Installation Using the Fax Capabilities of the ModemUsing Your Modem Where To Go From HereCommand Structure Executing CommandsBasic AT Commands Bold text Command FunctionLow speaker volume Commands are echoedTouch-tone dialing DS=nExtended AT Commands Modem is set up for dial-up line operation Guard tone disabled Disable originate-only mode US setting for off-hook-to-on-hook ratioMNP/V.42/V.42bis Commands Section Four S Registers Section Five Result Codes S Registers Function Range/units DefaultExtended Response Codes Connect 19200/V42BIS Modem does not respond to commands Section Six TroubleshootingModem does not dial Modem dials but does not connect42bis/V.42/MNP2-5 does not work Modem makes a connection but no data appears on your screenHigh pitch tone is heard whenever you answer the phone Section Nine FCC , DOC & Other Notices Section Eight Support and ServiceFCC Compliance DOC Compliance Information FCC Class B StatementDisclaimer, Copyright, And Other Notices