|
|
|
| ® |
|
|
|
|
|
|
|
| Table of Contents |
|
1 | General | 1 | ||
| 1.1 | Introduction | 1 | |
| 1.2 | Firmware Revision | 1 | |
| 1.3 | Features | 1 | |
| 1.4 | FPM100 Accessories | 2 | |
| 1.5 | Quick Install | 2 | |
| 1.6 | Theory of Operation | 3 | |
|
| 1.6.1 | Choosing a Pressure Transducer Mounting Location for Tank Level |
|
|
| Measurement | 3 | |
|
| 1.6.2 | Accuracy of Tank Level Measurement | 3 |
2 | Installation | 4 | ||
| 2.1 | Unpacking the Box | 4 | |
| 2.2 | Choosing a Mounting Location | 5 | |
| 2.3 | Mounting the FPM100 | 5 | |
| 2.4 | Mounting the Pressure Transducer | 5 | |
|
| 2.4.1 | Pressure Measurement Applications | 5 |
|
| 2.4.2 | Tank Level Measurement Applications | 6 |
| 2.5 | Connecting the FPM100 | 7 | |
|
| 2.5.1 | NMEA 2000® Connection | 7 |
|
| 2.5.2 | Pressure Transducer Connections | 8 |
3 | Configuring the FPM100 | 9 | ||
| 3.1 | Configuring Channel Mode | 9 | |
| 3.2 | Configuring a Channel in Pressure/Vacuum Mode | 9 | |
|
| 3.2.1 | Configuring Instance | 9 |
|
| 3.2.2 | Configuring Label | 10 |
|
| 3.2.3 | Configuring Pressure at 4mA | 10 |
|
| 3.2.4 | Configuring Pressure at 20mA | 10 |
|
| 3.2.5 | Configuring Source | 10 |
|
| 3.2.6 | Configuring Data Damping Period | 10 |
| 3.3 | Configuring a Channel in Tank Mode | 10 | |
|
| 3.3.1 | Configuring Label | 10 |
|
| 3.3.2 | Configuring Pressure at 4mA | 11 |
|
| 3.3.3 | Configuring Pressure at 20mA | 11 |
|
| 3.3.4 | Configuring Tank Capacity | 11 |
|
| 3.3.5 | Tank Levels Calibration | 11 |
|
| 3.3.6 | Configuring Tank Number | 12 |
|
| 3.3.7 | Configuring Tank Type | 13 |
|
| 3.3.8 | Configuring Data Damping Period | 13 |
4 | Maintenance | 13 | ||
5 | Troubleshooting | 14 | ||
6 | Technical Specifications | 15 | ||
7 | Technical Support | 16 | ||
8 | Installation Template | 17 | ||
9 Maretron (2 Year) Limited Warranty | 18 | |||
Revision 1.3 | Page iii |