Liebert GXT3-10000T220 Environmental Conditions, Access to Area, Floor Loading, Inventory List

Page 11

Unpacking the UPS and Site Preparation

2.4Environmental Conditions

Install the Liebert® GXT3™ indoors in a controlled environment where it cannot be accidentally turned off. Place it on a level, even surface in an area with unrestricted airflow around the unit. The installation location must be free of water, flammable liquids, gases, corrosives and other conductive contaminants. Maintain a minimum clearance of 100mm (4 inches) in the front and rear of the UPS. Maintain an ambient temperature range of 0 to 40°C (32 -104°F).

See 8.0 - Specifications for acceptable environmental conditions.

NOTE

UPS operation in sustained temperatures outside the range of 15-25°C (59°-77°F) will reduce battery life.

2.5Access to Area

The area where the Liebert GXT3-10000T220 is to be placed must have sufficient space for installation procedures and for routine maintenance. The UPS is narrow enough to pass through standard doorways.

2.6Floor Loading

Ensure that the floor where the UPS will be installed will support the unit’s weight (see Table 9 for the unit’s weight).

2.7Inventory List

•CD containing:

•Liebert MultiLink® shutdown software

•Configuration Software

•User Manual

•Terminal Block Communication terminals

•Floor-mount brackets

•Warnings, safety instructions booklet and WEEE recycling sheet (ISO 14001 compliance)

•USB cable

•Hardwire terminal block cover plate and mounting screws

•Single input bypass jumper

•Battery cabinets contain one DC power cable

7

Image 11

Contents Liebert GXT3-10000T220 Page Table of Contents Communication MaintenanceImportant Safety Instructions Page Information for the Protection of the Environment Leakage CurrentLiebert GXT3-10000T220 control panel Introduction and System DescriptionOverview of UPS devices and batteries Type Model # Nominal powerDevice Overview Unpacking the UPS and Site Preparation Required Setup EquipmentInspection UnpackingInventory List Access to AreaEnvironmental Conditions Floor LoadingExternal Protection and Isolating Devices InstallationElectrical preparations Suggested Cable SizesRear Panel Cable Entry Cover Connecting Utility and LoadExternal Electrical Connections Terminal Blocks for UPSJumper removed for clarity Input and Output Connection RequirementsCabinet Connecting Power CablesExternal Battery Cabinets Operation Block DiagramFlashing LED Fault Battery UPS On BypassControl Panel Controls and Messages Lighted LEDsMenu tree Displayed text-system block and main menu Test Report Battery Setup ParametersBattery setup parameters ControlFault Cause Corrective steps Fault IndicatorsFault indicators Maintenance Bypass Procedure Initial UPS Startup ProcedureUPS Shutdown Procedure Self-Tests Return from Maintenance BypassMaintenance Breaker, Off Position Battery TestReplacement battery pack Test, Replacement and Disposal of BatteriesCleaning MaintenanceCommunication Any Mode ShutdownCommunication Interface Port Dry ContactLiebert IntelliSlot Communication Cards Battery Mode ShutdownOn Battery Low BatteryLiebert MultiLink Remote Emergency Power OffRepo switch connection diagram Problem Possible Cause Solution TroubleshootingTroubleshooting guide Liebert GXT3 specifications SpecificationsInternal Battery Parameters Battery cabinet specificationsTypical battery run times for the Liebert GXT3-10000T230 Dimensions, W x D x H, in. mmProduct Warranty Registration Care Ne tIs t Twor k