Lantronix ETS16PR, ETS8PS, ETS16PS, ETS32PR manual LAT Configuration, Translating LAT Error Codes

LAT Configuration

Figure 7-4. Translating LAT Error Codes

$ SHOW QUEUE/FULL/ALL queue_name (note the error code nnnnnnnn)

$ SET MESSAGE SYS$MESSAGE:NETWRKMSG.EXE $ EXIT %Xnnnnnnnn

Table 7-1. Troubleshooting LAT Configurations Using a Port

Area to Check	Explanation
The specified node	Use the Show Server command to verify.
name matches the
ETS node name
The specified port	Use the List Port 1 command to verify.
name matches the
port’s name
Table 7-2. Troubleshooting LAT configurations Using a Service
Area to Check		Explanation
The unit is licensed for LAT		To use LAT you must obtain a LAT license
		from your dealer or from Lantronix. Then
		enter the Define Protocol LAT License
		string command on your ETS.
The specified node name		Use the Show Server command.
matches the ETS node
name
The service name used		Use the Show Service Local Characteristics
matches the configured		command.
service name
The service is available		Use the Show Service Local Characteristics
		command from a network login. If the
		service rating is zero, the serial port is in
		use.
The LAT characteristic has		Use the Show Service Local Characteristics
been enabled on the		command from a network login.
service
The LAT symbiont is		Use the VMS command Show Queue/Full
specified as the queue		queue_name to see the queue
process on the VMS host		characteristics.
For DCPS: there is a		Lock the printer in PostScript mode and
bidirectional path to the		issue the Test Service PostScript Count n
printer and the printer is		command. This command sends a job to
locked into PostScript		the printer and waits for the response.
mode

ETS Installation Guide 43