Lantronix Ethernet manual Pack Control, Flush Input Buffer Serial to Network

		Web-Manager Configuration
	Baud Rate	The unit and attached serial device, such as a modem, must
		agree on a speed or baud rate to use for the serial connection.
		Valid baud rates are 300, 600, 1200, 2400, 4800, 9600
		(default), 19200, 38400, 57600, 115200, 230400, 460800, or
		921600. For baud rates 460 and 921 Kbps, the CPU
		Performance Mode must be set to High.
	Data Bits	Indicates the number of character bits. The default setting is 8.
	Parity	Checks for the parity bit. The default setting is None.
	Stop Bits	The stop bit follows the data and parity bits in serial
		communication. It indicates the end of transmission. The
		default setting is 1.
Pack Control
	Enable Packing	Select the checkbox to enable packing on the WiBox.
		Two firmware-selectable packing algorithms define how and
		when packets are sent to the network.
		The standard algorithm is optimized for applications in which
		the unit is used in a local environment, allowing for very small
		delays for single characters, while keeping the packet count
		low.
		The alternate packing algorithm minimizes the packet count
		on the network and is especially useful in applications in a
		routed Wide Area Network (WAN). Adjusting parameters in
		this mode can economize the network data stream.
		Disabled by default.
	Idle Gap Time	Select the maximum time for inactivity. The default time is 12
		milliseconds.
	Match 2 Byte Sequence	Use to indicate the end of a series of data to be sent as one
		group. The sequence must occur sequentially to indicate the
		end of data collection to the WiBox. The default setting is No.
	Match Bytes	Use to indicate the end of a series of data to be sent as one
		group. Set this value to 00 if specific functions are not needed.
	Send Frame Only	After the detection of the byte sequence, indicates whether to
		send the data frame or the entire buffer. Select Yes to send
		only the data frame. The default setting is No.
	Send Trailing Bytes	Select the number of bytes to send after the end-of-sequence
		characters. The default None.
Flush Input Buffer (Serial to Network)
	With Active Connect	Select Yes to clear the input buffer with a connection that is
		initiated from the device to the network. The default setting is
		No.
	With Passive Connect	Select Yes to clear the input buffer with a connection initiated
		from the network to the device. The default setting is No.

WiBox2100E User Guide 35