Lantronix Ethernet manual Later, there is only one setting for

		Troubleshooting
Problem/Message	Reason	Solution
Cannot establish an Ad Hoc	Ad Hoc network is not enabled in	Enable Ad Hoc network. Set Ad
network connection to the	the WiBox.	Hoc Network Name (IBSS) to
WiBox.		match. These are case-sensitive.
Note: With 6.x.x.x firmware and
later, there is only one setting for	Infrastructure Network Name	Set the Infrastructure Network
Network Name; it is the same for	(SSID) is set blank or different	Name (SSID) to the same name
both Infrastructure and Ad Hoc	from the Ad Hoc name and the	as the Ad Hoc name.
modes.
	WiBox is associated to
	Infrastructure Network
	The IP address is not set or not	Verify the IP address is set and in
	in same subnet as other Ad Hoc	the same subnet for each Ad Hoc
	PCs or the WiBox.	device.
Cannot ping or connect to the	The DHCP server is not	Contact the Network
WiBox DHCP name.	automatically setting the DHCP	Administrator to add the WiBox to
	name in DNS on the network.	DNS manually.
When you issue the ARP –S	Your user login does not have	Have your IT department log you
command in Windows, The ARP	the right to use this command on	in with sufficient rights.
entry addition failed: 5 message	this PC.
displays.
When you attempt to assign an	The ARP method only creates a	Telnet back to Port 1. Wait for it to
IP address to the unit by the	temporary password. When you	fail, then Telnet to port 9999
ARP method and Telnet to the	Telnet to port 1, the connection	again. Make sure you press Enter
device server through port 1, the	should fail. When you Telnet into	within 5 seconds.
connection fails.	port 9999 and do not press Enter
	quickly, the device server
	reboots, causing it to lose the IP
	address.
When you Telnet to port 9999,	To enter Setup Mode via Telnet,	Telnet to port 9999 again and
the Press Enter to go into Setup	the Enter key must be pressed	press Enter as soon as you see
Mode message displays.	within 5 seconds.	the Press Enter to go into Setup
However, nothing happens when		Mode message.
you press Enter, or your
connection is closed.
When you Telnet to port 1 to	You may have entered the	Confirm that the Ethernet address
assign an IP address to the	Ethernet address incorrectly with	that you entered with the ARP
device server, the Telnet window	the ARP command.	command is correct. The Ethernet
does not respond for a long time.		address must only include
		numbers 0-9 and letters A-F. In
		Windows and usually in Unix, the
		segments of the Ethernet address
		are separated by dashes. In some
		forms of Unix, the Ethernet
		address is segmented with
		colons.

WiBox2100E User Guide 83