Intellinet Network Solutions 524780 user manual Installation

Page 11

Installation

1.Connect the router to your ADSL cable through the supplied RJ11 cable.

2.Connect the router to your PC, hub or switch by attaching the Ethernet cable to the LAN port of the router.

3.Connect the power adapter to the power jack on the rear panel of the router.

4.The ADSL LED will be on if the router is connected to the ADSL cable and receives the ADSL signals successfully. If the LED is blinking, contact your ISP (Internet service provider) to check the problem.

NOTE: Use only the power adapter included with the router, and not any other power adapter.

5

Image 11

Contents Wireless 300N ADSL2+ FCC Part Federal Communications Commission Interference StatementFCC Caution TTE Compliance Statement SafetyContents Troubleshooting Glossary Specifications Introduction Minimum Requirements Package ContentsAdsl HardwareRear Panel ON/OFFStatus Description Front PanelInstallation Getting Started Setup WizardPage Page Automatically Set the ISP Page Page Manually Set the ISP Page Page Page Page Windows Vista IP Address SettingWindows XP Windows Page Web Management Configuration General Setup Section Quick Setup Page Time Zone SystemPassword Settings Remote Management WAN LANMIB SnmpSnmp 2 WAN Channel ConfigRFC1483 MER VCI VPIShould be routed ATM Setting MBS PCRCdvt SCRAdsl Setting 2.4 DNS Ddns 2.6 RIP ParameterDescription 3 LAN 192.168.2.1 Dhcp Relay Dhcp ModeDhcp Server Parameter Description Bridging ARP TableBasic Settings WirelessSsid Advanced Settings ParameterDescription Auto is the default authentication algorithm. It will Transmit the network name Ssid into open air at regular Security WPA2 AES for data encryption. The actual selection Access Control 4.5 WPS Parameter Description 5 QoS ParameterDescription TOS NAT Network Address TranslationsPort Forwarding Port Mapping Parameter Description Upnp Igmp Proxy 7.1 IP/Port Filtering FirewallListed in the table from connecting to the Internet MAC Filtering Page Fqdn URL BlockingDomain Blocking Routing Configuration Page ACL Configuration 7.7 DMZ Status Interface Adsl Tools Configuration ToolsPing Firmware UpgradeATM Loopback Reboot Diagnostic TestSteps Corrective Action TroubleshootingPage Forget my login username and/or password Initialization of the Adsl connection failed Bridge Default Gateway RouterGlossary 10Base-TISP Gateway Address Idle TimeoutDNS Server IP Address EthernetPort MAC AddressRFC PPPoA RFCPPPoE RFC ProtocolWeb-based Management Graphical User Interface GUI RouterSubnet Mask General SpecificationsStandards WPA Radius WirelessWPA Tkip WPA2 AES Environmental PowerPackage Contents LEDsFrançais EnglishDeutsch EspañolPolski ItalianoWarranty Information