Intellinet Network Solutions 524780 user manual Advanced Settings

Page 55

Control Sideband

Select the upper band or lower band for your radio

 

frequency. While “Upper” is selected, the channel options

 

are from 5 to 11. While “Lower” is selected, the channel

 

options are from 1 to 7.

Channel Number

This is the radio channel used by the wireless LAN. All

 

devices in the same wireless LAN should use the same

 

channel. Select the country and designate a channel that

 

the router will use. To let the router automatically find an

 

available channel with the highest signal strength, select

 

“Auto.”

Radio Power (mW)

Sets the maximum output power of the router. The higher

 

the output power, the wider the coverage range.

Associated Clients

Click to see the wireless clients connected to the router.

When you finish, click “Apply Changes.” You’ll see the following message displayed on Web browser.

Click “Continue” to save the settings made and go back to the Web management interface; click “Apply” to save the settings made and restart the router so the settings will take effect after it reboots.

5.2.4.2 Advanced Settings

This screen allows advanced users who have sufficient knowledge of wireless LANs to make configuration changes. These settings shouldn’t be changed unless you know exactly what will happen as a result.

49

Image 55
Contents Wireless 300N ADSL2+ FCC Part Federal Communications Commission Interference StatementFCC Caution TTE Compliance Statement SafetyContents Troubleshooting Glossary Specifications Introduction Minimum Requirements Package ContentsAdsl HardwareRear Panel ON/OFFStatus Description Front PanelInstallation Getting Started Setup WizardPage Page Automatically Set the ISP Page Page Manually Set the ISP Page Page Page Page Windows Vista IP Address SettingWindows XP Windows Page Web Management Configuration General Setup Section Quick Setup Page Time Zone SystemPassword Settings Remote Management WAN LANSnmp SnmpMIB 2 WAN Channel ConfigRFC1483 MER VCI VPIShould be routed ATM Setting MBS PCRCdvt SCRAdsl Setting 2.4 DNS Ddns 2.6 RIP ParameterDescription 3 LAN 192.168.2.1 Dhcp Relay Dhcp ModeDhcp Server Parameter Description Bridging ARP TableBasic Settings WirelessSsid Advanced Settings ParameterDescription Auto is the default authentication algorithm. It will Transmit the network name Ssid into open air at regular Security WPA2 AES for data encryption. The actual selection Access Control 4.5 WPS Parameter Description 5 QoS ParameterDescription TOS NAT Network Address TranslationsPort Forwarding Port Mapping Parameter Description Upnp Igmp Proxy 7.1 IP/Port Filtering FirewallListed in the table from connecting to the Internet MAC Filtering Page Fqdn URL BlockingDomain Blocking Routing Configuration Page ACL Configuration 7.7 DMZ Status Interface Adsl Tools Configuration ToolsPing Firmware UpgradeATM Loopback Reboot Diagnostic TestSteps Corrective Action TroubleshootingPage Forget my login username and/or password Initialization of the Adsl connection failed Bridge Default Gateway RouterGlossary 10Base-TISP Gateway Address Idle TimeoutDNS Server IP Address EthernetPort MAC AddressRFC PPPoA RFCPPPoE RFC ProtocolSubnet Mask RouterWeb-based Management Graphical User Interface GUI Standards SpecificationsGeneral WPA Tkip WPA2 AES WirelessWPA Radius Environmental PowerPackage Contents LEDsFrançais EnglishDeutsch EspañolPolski ItalianoWarranty Information