Intellinet Network Solutions 524780 manual

	WPA2 (AES) for data encryption. The actual selection
	of the encryption methods will depend on the clients.
Use 802.1x	IEEE 802.1x is an authentication protocol. Every user
Authentication	must use a valid account to log in to this wireless router
	before accessing the wireless LAN. The authentication is
	processed by a RADIUS server. Check this box to
	authenticate a user by IEEE 802.1x.
WEP-64Bits	WEP is a lower level of security than WPA, and supports
	64-bit and 128-bit key lengths to encrypt the wireless
	data. The longer key length will provide higher security.
	When “WEP-64Bits” is selected, you need to enter
	exactly 5 ASCII characters (“a-z” and “0-9”) or 10
	hexadecimal digits (“0-9,” “a-f”) for each Key (1-4).
WEP-128Bits	When “WEP-128Bits” is selected, you need to enter
	exactly 13 ASCII characters (“a-z” and “0-9”) or 26
	hexadecimal digits (“0-9,” “a-f”) for each Key (1-4).
WPA Authentication	There are two types of authentication mode for WPA.
Mode	• Enterprise (RADIUS) uses an external RADIUS server
	to perform user authentication. To use RADIUS, enter
	the IP address of the RADIUS server, the RADIUS port
	(default is 1812) and the shared secret from the
	RADIUS server. Refer to the “Authentication RADIUS
	Server” setting below for RADIUS setting.
	• Personal (Pre-Shared Key) authentication is based on a
	shared secret that is known only by the parties involved.
	To use WPA Pre-Shared Key, select the key format and
	enter a password in the “Pre-Shared Key Format” and
	“Pre-Shared Key” settings.
Pre-Shared Key	You can select Passphrase (alphanumeric format) or
Format	Hexadecimal Digits (in the “A-F,” “a-f” and “0-9” range) to
	be the Pre-shared Key. For example:
	Passphrase: ”iamguest”
	Hexadecimal Digits: “12345abcde”
Pre-Shared Key	Enter 8-63 characters as the “Pre-Shared Key.”
Authentication	Enter the port (default is 1812), the IP address and the

WPA2 (AES) for data encryption. The actual selection