Intellinet Network Solutions 524780 user manual Parameter Description

Page 63

Parameter

Description

Disable WPS

Check to disable Wi-Fi Protected Setup.

WPS Status

When the settings are factory defaults (out of the box), it

 

is set to an open security and unconfigured state. “WPS

 

Status” will display it as “UnConfigured.” If it already

 

shows “Configured,” some registrars such as Vista WCN

 

will not configure the router, and you’ll need to go to the

 

Backup/Restore screen and click “Reset” to reload the

 

factory default settings.

Self-PIN Number

“Self-PIN Number” is the router’s PIN. Whenever you

 

want to change the PIN, click “Regenerate PIN” and

 

“Apply Changes.” To create your own PIN, enter a four-

 

digit PIN without checksum and click “Apply Changes.”

 

However, this would not be recommended, since the

 

registrar side needs to be supported with a four-digit PIN.

Regenerate PIN

Click to regenerate the Self-PIN Number.

Push Button

Clicking this button will invoke the PBC method of WPS.

Configuration

It is only used when the router acts as a registrar.

Start PBC

Click to start the Push Button method of WPS.

Reset

Click to restore the original values.

Client PIN Number

This is only used when users want their station to join the

 

router’s network. The length of the PIN is limited to four

57

Image 63
Contents Wireless 300N ADSL2+ FCC Part Federal Communications Commission Interference StatementFCC Caution TTE Compliance Statement SafetyContents Troubleshooting Glossary Specifications Introduction Minimum Requirements Package ContentsAdsl HardwareRear Panel ON/OFFStatus Description Front PanelInstallation Getting Started Setup WizardPage Page Automatically Set the ISP Page Page Manually Set the ISP Page Page Page Page Windows Vista IP Address SettingWindows XP Windows Page Web Management Configuration General Setup Section Quick Setup Page Time Zone SystemPassword Settings Remote Management WAN LANSnmp SnmpMIB 2 WAN Channel ConfigRFC1483 MER VCI VPIShould be routed ATM Setting MBS PCRCdvt SCRAdsl Setting 2.4 DNS Ddns 2.6 RIP ParameterDescription 3 LAN 192.168.2.1 Dhcp Relay Dhcp ModeDhcp Server Parameter Description Bridging ARP TableBasic Settings WirelessSsid Advanced Settings ParameterDescription Auto is the default authentication algorithm. It will Transmit the network name Ssid into open air at regular Security WPA2 AES for data encryption. The actual selection Access Control 4.5 WPS Parameter Description 5 QoS ParameterDescription TOS NAT Network Address TranslationsPort Forwarding Port Mapping Parameter Description Upnp Igmp Proxy 7.1 IP/Port Filtering FirewallListed in the table from connecting to the Internet MAC Filtering Page Fqdn URL BlockingDomain Blocking Routing Configuration Page ACL Configuration 7.7 DMZ Status Interface Adsl Tools Configuration ToolsPing Firmware UpgradeATM Loopback Reboot Diagnostic TestSteps Corrective Action TroubleshootingPage Forget my login username and/or password Initialization of the Adsl connection failed Bridge Default Gateway RouterGlossary 10Base-TISP Gateway Address Idle TimeoutDNS Server IP Address EthernetPort MAC AddressRFC PPPoA RFCPPPoE RFC ProtocolRouter Subnet MaskWeb-based Management Graphical User Interface GUI Specifications StandardsGeneral Wireless WPA Tkip WPA2 AESWPA Radius Environmental PowerPackage Contents LEDsFrançais EnglishDeutsch EspañolPolski ItalianoWarranty Information