Intellinet Network Solutions 524780 user manual

Page 79

Destination

The destination can be specified as the IP address of a

 

subnet or a specific host in the subnet. It can also be

 

specified as all zeros to indicate the route should be used

 

for all destinations for which no other route is defined

 

(this is the route that creates the default gateway).

Subnet Mask

The network mask of the destination subnet. The default

 

gateway uses a mask of 0.0.0.0.

Next Hop

The IP address of the next hop through which traffic will

 

flow toward the destination subnet.

Metric

Defines the number of hops between network nodes that

 

data packets travel. The default value is 0, which means

 

that the subnet is directly one hop away on the local LAN

 

network.

Interface

The WAN interface to which a static routing subnet is to

 

be applied.

Show Routes

Click to view the router’s routing table.

Static Route Table

Click “Update” to update the selected destination route in

 

the Static Route Table. Click “Delete Selected” to delete

 

a selected destination route in the table.

When you finish, click “Apply Changes.” You’ll see the following message displayed on Web browser.

Click “Continue” to save the settings made and go back to the Web management interface; click “Apply” to save the settings made and restart the router so the settings will take effect after it reboots.

73

Image 79
Contents Wireless 300N ADSL2+ FCC Part Federal Communications Commission Interference StatementFCC Caution TTE Compliance Statement SafetyContents Troubleshooting Glossary Specifications Introduction Minimum Requirements Package ContentsAdsl HardwareRear Panel ON/OFFStatus Description Front PanelInstallation Getting Started Setup WizardPage Page Automatically Set the ISP Page Page Manually Set the ISP Page Page Page Page Windows Vista IP Address SettingWindows XP Windows Page Web Management Configuration General Setup Section Quick Setup Page Time Zone SystemPassword Settings Remote Management WAN LANSnmp SnmpMIB 2 WAN Channel ConfigRFC1483 MER VCI VPIShould be routed ATM Setting MBS PCRCdvt SCRAdsl Setting 2.4 DNS Ddns 2.6 RIP ParameterDescription 3 LAN 192.168.2.1 Dhcp Relay Dhcp ModeDhcp Server Parameter Description Bridging ARP TableBasic Settings WirelessSsid Advanced Settings ParameterDescription Auto is the default authentication algorithm. It will Transmit the network name Ssid into open air at regular Security WPA2 AES for data encryption. The actual selection Access Control 4.5 WPS Parameter Description 5 QoS ParameterDescription TOS NAT Network Address TranslationsPort Forwarding Port Mapping Parameter Description Upnp Igmp Proxy 7.1 IP/Port Filtering FirewallListed in the table from connecting to the Internet MAC Filtering Page Fqdn URL BlockingDomain Blocking Routing Configuration Page ACL Configuration 7.7 DMZ Status Interface Adsl Tools Configuration ToolsPing Firmware UpgradeATM Loopback Reboot Diagnostic TestSteps Corrective Action TroubleshootingPage Forget my login username and/or password Initialization of the Adsl connection failed Bridge Default Gateway RouterGlossary 10Base-TISP Gateway Address Idle TimeoutDNS Server IP Address EthernetPort MAC AddressRFC PPPoA RFCPPPoE RFC ProtocolSubnet Mask RouterWeb-based Management Graphical User Interface GUI Standards SpecificationsGeneral WPA Tkip WPA2 AES WirelessWPA Radius Environmental PowerPackage Contents LEDsFrançais EnglishDeutsch EspañolPolski ItalianoWarranty Information