Intellinet Network Solutions 524780 user manual Troubleshooting, Steps Corrective Action

Page 89

6 Troubleshooting

The LAN LED on the front panel does not light up.

STEPS

CORRECTIVE ACTION

1

Check the Ethernet cable connections between your router and

 

the computer or hub.

2

Check for faulty Ethernet cables.

3

Make sure your computer’s Ethernet card is working properly.

4

If these steps fail to correct the problem, contact your local

 

distributor for assistance.

The ADSL LED on the front panel does not light up.

STEPS

CORRECTIVE ACTION

1

Check the telephone wire and connections between router DSL

 

port and the wall jack.

2

Make sure that the telephone company has checked your phone

 

line and set it up for DSL service.

3

Reset your ADSL line to reinitialize your link to the DSLAM.

4

If these steps fail to correct the problem, contact your local

 

distributor for assistance.

I cannot access the Web management.

STEPS

CORRECTIVE ACTION

1

Make sure you are using the correct IP address of router.

2

Your computer and the router’s IP addresses must be on the

 

same subnet for LAN access.

3

If you have changed router’s LAN IP address, then enter the new

 

one as the URL.

83

Image 89
Contents Wireless 300N ADSL2+ FCC Part Federal Communications Commission Interference StatementFCC Caution TTE Compliance Statement SafetyContents Troubleshooting Glossary Specifications Introduction Minimum Requirements Package ContentsRear Panel HardwareON/OFF AdslStatus Description Front PanelInstallation Getting Started Setup WizardPage Page Automatically Set the ISP Page Page Manually Set the ISP Page Page Page Page Windows Vista IP Address SettingWindows XP Windows Page Web Management Configuration General Setup Section Quick Setup Page Time Zone SystemPassword Settings Remote Management WAN LANMIB SnmpSnmp 2 WAN Channel ConfigRFC1483 MER VCI VPIShould be routed ATM Setting Cdvt PCRSCR MBSAdsl Setting 2.4 DNS Ddns 2.6 RIP ParameterDescription 3 LAN 192.168.2.1 Dhcp Relay Dhcp ModeDhcp Server Parameter Description Bridging ARP TableBasic Settings WirelessSsid Advanced Settings ParameterDescription Auto is the default authentication algorithm. It will Transmit the network name Ssid into open air at regular Security WPA2 AES for data encryption. The actual selection Access Control 4.5 WPS Parameter Description 5 QoS ParameterDescription TOS NAT Network Address TranslationsPort Forwarding Port Mapping Parameter Description Upnp Igmp Proxy 7.1 IP/Port Filtering FirewallListed in the table from connecting to the Internet MAC Filtering Page Fqdn URL BlockingDomain Blocking Routing Configuration Page ACL Configuration 7.7 DMZ Status Interface Adsl Tools Configuration ToolsPing Firmware UpgradeATM Loopback Reboot Diagnostic TestSteps Corrective Action TroubleshootingPage Forget my login username and/or password Initialization of the Adsl connection failed Glossary Default Gateway Router10Base-T BridgeDNS Server IP Address Idle TimeoutEthernet ISP Gateway AddressPort MAC AddressPPPoE RFC PPPoA RFCProtocol RFCWeb-based Management Graphical User Interface GUI RouterSubnet Mask General SpecificationsStandards WPA Radius WirelessWPA Tkip WPA2 AES Package Contents PowerLEDs EnvironmentalDeutsch EnglishEspañol FrançaisPolski ItalianoWarranty Information