Installing and Connecting the AC Power Supply
INSTALLING AND CONNECTING THE AC POWER SUPPLY
To install and connect the AC power supply to the NetScreen-5000 Series:
1.On the NetScreen-5200, slide the power supply into one of the power compartments in the back of the system.
On the NetScreen-5400, slide the power supply into one of the power compartments on the front of the system.
2.Fasten the power supply to the system by tightening the corner screws into the eyelets on the sides of the power supply.
3.If you want to install two power supplies in the NetScreen-5200 or three power supplies in the NetScreen-5400, then repeat steps 1 and 2 for the remaining power supplies.
4.Connect the female end of a standard power cord to the male connector on the back of each power supply.
5.Connect each power cord to a standard 100-240-Volt power outlet.
Note: Whenever you deploy two or more power supplies to a NetScreen-5000 Series system, connect each to a different power source. Each power supply is intended to receive power from separate feeds.
6.Turn the power switches on.
Note: If there are multiple power supplies in the NetScreen-5000 Series system and any of them are off, then the Alarm LED on the management module glows red. This alarm indicates that maximum system stability requires all installed power supplies to be operational.
INSTALLING AND WIRING A DC POWER SUPPLY
To install and connect the DC power supply to the NetScreen-5000 Series system:
1.On the NetScreen-5200, slide the power supply into one of the power compartments in the back of the system.
On the NetScreen-5400, slide the power supply into one of the power compartments on the front of the system.
2.Fasten the power supply to the system by tightening the corner screws into the eyelets on the sides of the power supply.
3.If you want to install two power supplies in the NetScreen-5200 or three power supplies in the NetScreen-5400, then repeat steps 1 and 2 for the remaining power supplies.
