Juniper Networks 5000 manual Configuring the Chassis Alarm, Http//10.100.2.183

Configuring the Chassis Alarm

For example, if you assigned the MGT interface an IP address of 10.100.2.183/16, then enter:

http://10.100.2.183

The NetScreen WebUI software displays the login prompt.

3.Enter netscreen in both the Admin Name and Password fields, and then click Login. (Use lowercase letters only. The Admin Name and Password fields are both case sensitive.)

The NetScreen WebUI application window appears.

CONFIGURING THE CHASSIS ALARM

The NetScreen-5000 Series system allows you to configure the chassis alarm, an audible warning that sounds when a system failure or hazardous event occurs. To determine which failures and events trigger the chassis alarm:

1.Configure the audible alarms by executing the following command: set chassis audible-alarmstring

where string can be any of the following keywords:

all	Enables all chassis alarms.
battery	Sets the chassis alarm to sound when a battery fails.
fan-failed	Sets the chassis alarm to sound when a fan fails.
power-failed	Sets the chassis alarm to sound when a power supply fails.
temperature	Sets the chassis alarm to sound when the temperature goes outside of
	the acceptable range.

2.After configuring the alarm, it is advisable to view alarm environment information by executing the following command:

get chassis

NetScreen-5000 Series 31