Huawei B970 manual SIM Settings

Page 14

SIM Settings

Restoring the Factory Defaults

If you need to reconstruct the network or you forget the changes of some parameters, you can choose to restore factory defaults and reconfigure the device.

Click to access the Restore Defaults page, and then click Restore.

Note	After this operation, all configurations are
	restored to the defaults.

Restarting the Device

1Click to access the Reboot page.

2Click Reboot.

Viewing the Version Information

Click to access the Version page.

SIM Settings

Click to access the SIM Settings page.

When the device works in the ROM-SIM mode, the page is not available.

Enabling or Disabling the PIN Code

1Click .

2Select Enable/Disable in the PIN Code Operation list box.

3Enter the correct PIN code.

4Click Apply.

Changing the PIN Code

When the PIN code protection is enabled, you can reset the PIN code.

1 Click .

Image 14

Contents Wonderful Communication, Mobile Life User GuidePostal Code Administration Building, Huawei Technologies ChinaAddress Safety Precautions Table of Contents Management Page Overview 1Using the ManagementLogging In to the Management Device StatusQuick Setup Optimized SettingsViewing Configuration Info Viewing Configuration InfoConfiguring Wlan Settings Configuring PPP Profile SettingsConfiguring PPP Dial-up Settings Quick SetupValidating Quick Setup Accessing the InternetConfiguring Wlan Encryption Accessing the InternetIf PPP Connection is Auto or On Current network connection statusConfiguration Requirements 2Configuring Your ComputerWireless Configuration Configuring the Wireless NetworkDisabling Proxy Settings Configuring the PC NetworkConfiguring the Network Connection Configuring the PC NetworkSettings 3Advanced SettingsChanging the Password OverviewSystem Management User ControlUpgrading the device Set the StatusSIM Settings Mobile Network Settings Mobile Network SettingsSetting the Preferred Mode and Band Auto Validating PIN CodeConfiguring the PPP Settings Dial-up SettingsConfiguring the Mode for Searching Network Dial-up SettingsManaging the Profile List Dhcp SettingsDhcp Settings Wlan Settings Wlan SettingsWlan Basic Settings Enabling or Disabling the WlanWlan Advance Settings Configuring the MAC Filter Wlan BridgeClick Ok Validate Click Apply to validate Dynamic DNS SettingsDynamic DNS Settings Delete Click in the Modification columnEnter the IP Address/ Netmask/Gateway/ Metric Static Route SettingsStatic Route Settings LAN MAC Filter 4Security Settings OptionalFirewall Switch LAN IP FilterSelect Protocol and Status Virtual ServerVirtual Server Validate Click ApplyDMZ Settings DMZ SettingsUPnP Settings Select Enable/Disable for UPnP Status toRemote Management What to do if a PC in the Wlan cannot access the WLAN? 5TroubleshootingWhat to do if a PC in the LAN cannot access the Internet? What to do if I forgot the IP address of the LAN interface?Choose Start Run 6Abbreviations