Huawei B970 manual Dynamic DNS Settings, Click Ok Validate Click Apply to validate

Page 21

MAX Associations Limit: It refers to the maximum number of connections. It is used to set the maximum number of concurrent WLAN users on the device.

Mode: It refers to the WLAN accessing mode. The device can work in two modes, as shown in the following table. The default value is Access Point.

Mode

Description

Wireless

It is used to connect two or more access

Bridge

points.

Access

The access points meeting the IEEE

Point

802.11b/g standard or the wireless

 

terminals can connect the wireless

 

device.

Bridge Restriction: It refers to the limitation to the peer MAC addresses. When it is Disabled, the device can access all the remote bridges; when it is Enabled, the device can only access the remote bridges that the addresses are in the address list.

Bridges: It refers to the physical address of the remote peer bridge. The device supports the point-to-multipoint (PTM) bridge mode.

Peer MAC Address: It refers to the physical address list of the remote peer bridges.

Link Status: Up shows the successful connection and Down shows the failed connection.

Dynamic DNS Settings

Dynamic DNS Settings

The DDNS feature will update Internet IP which bound with registered Domain name periodically.

1Click to access the DDNS page.

2Configure the parameters of DDNS.

Provider: By default, the service provider is dyndns.org.

Host Name/Username/Password: Enter the value for DDNS registration.

3Click Ok.

Validate: Click Apply to validate.

Change: Click in the Modification column.

Delete: Click in the Modification column.

3

Advanced Settings

17

Image 21
Contents User Guide Wonderful Communication, Mobile LifeAdministration Building, Huawei Technologies China AddressPostal Code Safety Precautions Table of Contents Logging In to the Management 1Using the ManagementManagement Page Overview Device StatusViewing Configuration Info Optimized SettingsQuick Setup Viewing Configuration InfoConfiguring PPP Dial-up Settings Configuring PPP Profile SettingsConfiguring Wlan Settings Quick SetupConfiguring Wlan Encryption Accessing the InternetValidating Quick Setup Accessing the InternetCurrent network connection status If PPP Connection is Auto or OnWireless Configuration 2Configuring Your ComputerConfiguration Requirements Configuring the Wireless NetworkConfiguring the Network Connection Configuring the PC NetworkDisabling Proxy Settings Configuring the PC NetworkChanging the Password 3Advanced SettingsSettings OverviewUpgrading the device User ControlSystem Management Set the StatusSIM Settings Setting the Preferred Mode and Band Mobile Network SettingsMobile Network Settings Auto Validating PIN CodeConfiguring the Mode for Searching Network Dial-up SettingsConfiguring the PPP Settings Dial-up SettingsDhcp Settings Dhcp SettingsManaging the Profile List Wlan Basic Settings Wlan SettingsWlan Settings Enabling or Disabling the WlanWlan Advance Settings Wlan Bridge Configuring the MAC FilterDynamic DNS Settings Dynamic DNS SettingsClick Ok Validate Click Apply to validate Delete Click in the Modification columnStatic Route Settings Static Route SettingsEnter the IP Address/ Netmask/Gateway/ Metric Firewall Switch 4Security Settings OptionalLAN MAC Filter LAN IP FilterVirtual Server Virtual ServerSelect Protocol and Status Validate Click ApplyUPnP Settings DMZ SettingsDMZ Settings Select Enable/Disable for UPnP Status toRemote Management What to do if a PC in the LAN cannot access the Internet? 5TroubleshootingWhat to do if a PC in the Wlan cannot access the WLAN? What to do if I forgot the IP address of the LAN interface?Choose Start Run 6Abbreviations