Zenith XBS245 warranty Symptom Cause Correction, Audio in Optical, Moisture Condensation

Page 40

Troubleshooting (Continued)

Symptom	Cause	Correction

Severe hum or noise is	The plugs and jacks are dirty.	Wipe them with a cloth slightly mois-
heard.		tened with alcohol.
	The disc is dirty.	Clean the disc.

	The speakers and components are	Connect the speakers and components
	connected poorly.	securely.

	The DVD+VCR is located too close to	Move your TV away from the audio
	the TV.	components.

Radio stations cannot	The antenna is positioned or connected	Connect the antenna securely.
be tuned in.	poorly.
		Adjust the antennas and connect an
		external antenna if necessary.

	The signal strength of the stations is too	Tune in the station manually.
	weak (when tuning in with automatic
	tuning).

	No stations have been preset or preset	Preset the stations (page 37).
	stations have been cleared (when
	tuning by scanning preset stations).

No sound from DIGITAL	DVD+VCR source is not set to DIGITAL	Select OPTICAL by pressing AUX.
AUDIO IN (OPTICAL).	AUDIO IN (OPTICAL).
The remote control	The remote control is not pointed at the	Point the remote control at the remote
does not work properly.	remote sensor of the DVD+VCR.	sensor of the DVD+VCR.
	The remote control is too far from the	Operate the remote control within 23 ft
	DVD+VCR.	(7 m).

	There is an obstacle in the path of the	Remove the obstacle.
	remote control and the DVD+VCR.

	The batteries in the remote control are	Replace the batteries with new ones.
	exhausted.

	This remote control uses same buttons	When using a VCR, first press the VCR
	for VCR and DVD (ex. PLAY).	button. When using a DVD, first press
		the DVD button.

Moisture Condensation

Moisture condensation can occur:		In locations where moisture condensation may occur:

•	When the DVD+VCR is moved from a cold place to a	•	Keep the DVD+VCR plugged into an AC power outlet
	warm place.		with POWER On. This will help prevent condensation.
•	Under extremely humid conditions.	•	When condensation has occurred, wait a few hours
			for the DVD+VCR to dry before using it.

40

Image 40

Contents Installation and Operating Guide Warranty Safety Precautions Regulatory Information FCC PartImportant Safety Instructions Table of Contents Remote control battery installation Remote Control Operation RangeBefore Use Playable DiscsPrecautions About SymbolsFront Panel Indicates sound mode is Display WindowDigital Audio PrologicRemote Control Rear Panel RF OUT DVD/VCR OUTANT.IN Digital Audio in OpticalConnecting Antenna/Cable TV to ConnectionsConnections Basic TV Connections Optional TV ConnectionsSpeaker Positioning Connections Speaker System ConnectionsDVD+VCR Digital Device Connections Connections Radio Antenna ConnectionsGame Device Hdtv Receiver Rear of DVD+VCR Front of DVD+VCR Selecting the Input/Output Source VCR RadioMini Glossary for Sound Mode Before Operation Sound Mode DescriptionsSurround OFF 2CH Stereo Sound Mode When DVD is insertedWhen DVD is inserted and Prologic II indicator lights Sound LevelDelay Time Setting Surround delay time settingCenter delay time setting Dolby Digital mode only Before OperationSetting the On-Screen Display Before Operation VCR Mode On-Screen Display OSDMenu Selection Before Operation VCR Mode Using the VCR Setup Menu Channel SelectionBefore Operation VCR Mode Setting the Clock Press Menu when finished OteAuto Clock Set Manual Clock SetBefore Operation DVD Mode General ExplanationOn-Screen Display On-screen display operationBefore Operation DVD Mode Initial Settings Initial Settings General OperationLanguage PictureParental Control Rating DVDCountry Code DVD Changing the 4-digit codeVCR Mode Tape Playback Normal Playback Special Effect PlaybackVCR Mode Tape Recording Normal Recording Timer RecordingTo pause the recording To record one TV program while watching anotherChecking Erasing the Timer Program VCR Mode Tape RecordingProgram Priority Instant Timer Recording One-Touch Record Checking the Recording TimeTo extend the Recording Time Dubbing and EditingVCR Mode Tape Recording Sound Setup VCR Mode Other Features Tape Counter Memory Feature Additional InformationDVD Mode Operation Playing a DVD General FeaturesMoving to another Title DVD Moving to another ChapterDVD Mode Operation General Features Special DVD Features DVD DVD Mode Audio CD Operation Playing Audio CDs and MP3 discs Programmed Playback with Audio CD and MP3 Discs Repeat Programmed TracksErasing a Track from Program List Erasing the Complete Program ListDVD Mode Additional Information Video Mode Setting DVDScreen Saver About MP3Radio Operation Presetting Radio Stations To listen to non-preset radio stationsListening to the Radio To clear all the memorized stationsSymptom Cause Solution TroubleshootingPlace the disc with the playback side down Camcorder image is not Audio in Optical Symptom Cause CorrectionMoisture Condensation Language Code List Code LanguageCountry Code List Code CountrySpecifications Accessory SpeakersAmplifier Line 1, Line 2, OpticalReference Page Reference Zenith Electronics Corporation