GarrettCom 1016, 1024, 1008 manual Bonus port for optional Basic AUI port PM card BPM shown

Magnum 1000 Workgroup Hubs Installation and User Guide (04/02)

Bonus port for optional

Basic AUI port PM card (BPM shown)

J1-RPM

J1

	J4
J4-RPM		J4
J4-RPM

NOTE:

Use J1 and J4 for Basic AUI ports Use J1-RPM and J4-RPM for PMs

PM Ribbon cable with 16 pin headers.

(Included only when PM is factory installed. May be ordered separately as part # CBL-PM)

Figure 2.3b: Model 1024 Internal Connections, Basic AUI port and Bonus Port

2.4Bonus Port Configuration Options - RPMs and BPMs

Magnum 1000 Workgroup Hubs may be configured with any Repeater Port Module (RPM) or Bridge Port Module (BPM) in the rear bonus port. (For the 1008, this is done by exchanging the basic AUI port for a Port Module). An RPM may be used to provide connectivity, such as to a backbone, via any standard Ethernet media. A BPM may be used to provide local-bridge isolation for the 1000 Workgroup Hub’s users.

RPMs are available for the following six Ethernet connector types: BNC (ThinNet or 10BASE2), AUI (10BASE5 or ThickNet, DB-15 female for most transceiver connections), DTE (DB-15 male-AUI for direct connects), ST (Ethernet multi-mode Fiber ST), SMF (Ethernet single-mode Fiber), and RJ-45 (10BASE-T UTP and STP). They are shown in Figure 2.4a.

Figure 2.4a: Magnum RPM Cards: RPM-BNC, RPM-AUI,

RPM-DTE, RPM-FST, RPM-SMF & RPM-TP.

www . GarrettCom . com

9