GarrettCom 1016 Magnum 1000 Workgroup Hubs, Installation and User Guide 04/02, AC Power, LEDs

Magnum 1000 Workgroup Hubs		Installation and User Guide (04/02)
	AC Power
	115 - 230 VAC		Basic AUI Port

Figure 2.2.1b: Rear view - Magnum 1008 Workgroup Hub with the basic AUI port

As an alternative to the basic AUI port, it is possible (at the time of initial order) to replace the basic AUI rear port with any Magnum Port Module (PM). (See Figure 2.2.1c). This option gives the Magnum 1008 great flexibility to easily conform to any standard Ethernet media environment. When configured with a Repeater Port Module (RPM), the rear port can be used for direct connection to any standard Ethernet media. With a Bridge Port Module (BPM), the rear port is used to bridge-isolate the Magnum 1008 from the rest of the network, increasing bandwidth for both the local users and the rest of the network. Refer to Section 2.4 for Magnum Port Module information. (NOTE: The Magnum 1008’s basic AUI port is NOT an RPM-AUI, it is

simply an AUI port without any	AC Power	Port Module
LEDs).
	115 - 230 VAC	(RPM-FST shown)

Figure 2.2.1c: Rear view - Magnum 1008 Workgroup Hub configured with PM

2.2.2Magnum 1016 and 1024 Workgroup Hubs

The Magnum 1016 Workgroup Hub is equipped with 16 front-mounted, shielded RJ-45 ports, 1 rear-mounted basic AUI port and 1 rear Bonus Port slot (see Figure 2.2.2a). The left-most front RJ-45 port (port 1) is equipped with a slide switch to allow cascading or an up-link without a crossover cable.

Magnum 1016

Workgroup Hub

GARRETT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Figure 2.2.2a: Front view - Magnum 1016 Workgroup Hub

The Magnum 1024 Workgroup Hub is equipped with 24 front-mounted, shielded RJ-45 ports, 1 rear-mounted AUI port and 1 rear Bonus Port slot (see Figure 2.2.2b).

www . GarrettCom . com

6