GE EPM 5300, EPM 5200, EPM 5350 Programming Steps, Group 0-FUNCTION Number Description

CHAPTER 9: PROGRAMMING GROUP 0 – GLOBAL METER SETUP

PROGRAMMING STEPS:

1.Enter in GROUP 0, FUNCTION 4, PACK ‘P’, Segment C and D: UP, UP.

2.Enter in GROUP 5, FUNCTION 4, LIMIT 1, Segments B, C, and D: DOWN, UP, DOWN. Value: 58.00.

3.Enter in GROUP 5, FUNCTION 4, LIMIT 2, Segments B, C, and D: UP, UP, DOWN. Value: 62.00.

Example 2: Normally reset—non-event condition is reset relay

Relay 1 will be “SET” if the instantaneous reading for amps is below 4.00 or above 5.00 amps. Under all other conditions the relay will be “RESET”.

NOTE: Under this setup the relay will NOT act as a protective switch.

	S E T	L M 1
5 . 0 0	A
	R E S E T
4 . 0 0	A	L M 2
	S E T
0 . 0 0	A	R E S E T
	N O P O W E R T O T H E U N I T

PROGRAMMING STEPS:

1.Enter in GROUP 0, FUNCTION 4, PACK ‘p’, Segments C and D: DOWN, DOWN

2.Enter in GROUP 4, FUNCTION 2, LIMIT 1, Segments: B, C, and D: UP, UP, DOWN. Value: 5.00

3.Enter in GROUP 4, FUNCTION 2, LIMIT 2, Segments: DOWN, UP, DOWN. Value: 4.00

GROUP 0—FUNCTION NUMBER	DESCRIPTION
04.P	Controls Relay 1
05.P	Controls Relay 2 (and 3 if NL4)

Relay Mode: Group 0, Functions 4–5

GE Multilin EPM 5000 series Advanced Power Meters 51