GE EPM 5300, EPM 5200, EPM 5350 instruction manual To change Time Delays, To program Relay

CHAPTER 9: PROGRAMMING GROUP 0 – GLOBAL METER SETUP

To change Time Delays:

NOTE: Press MAX/MIN/LIMITS at any time, to cancel before storing the last digit or Switch.

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR
MAX/MIN	VOLTS AMPS	POWER	PHASE
LIMITS			NEXT

MAX			AC VOLTS
			A B C A B C
MIN			N N N B C A
LM1
LM2			AC AMPS
				A B C N
				POWER
				PF
				KW
				KVA
KVAH	KWH		FREQ	KVAR
MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

Step 1:	Step 2:
a. Enter Group Level of Programming Mode	To program Relay 1:
(see Chp. 8).	a. Press MAX/MIN/LIMITS until Function 04.P appears
b. Press MAX/MIN/LIMITS until 0. appears in upper
	in upper display.
display.	To program Relay 2 and 3:
c. Press AMPS to activate the Group.
	a. Press MAX/MIN/LIMITS until Function 05.P appears.
	b. Press VOLTS once to display 04.0 (On to Off delay
	time).
	c. Press VOLTS twice to display 04.1 (Off to On delay
	time).
	! Lower display indicates current Time Delays.

MAX	AC VOLTS
	A B C A B C
MIN	N N N B C A
LM1
LM2	AC AMPS
	A B C N
	POWER

			PF
			KW
			KVA
KVAH	KWH	FREQ	KVAR
MAX/MIN	VOLTS AMPS	POWER	PHASE
LIMITS			NEXT

Step 3:

a.Press AMPS to begin Data Entry Sequence.

!The previous value shifts to middle display and four dashes appear in lower display.

b. Press VOLTS until number appears.

c. Press AMPS to store each number.

MAX			AC VOLTS
			A B C A B C
MIN			N N N B C A
LM1
LM2			AC AMPS
				A B C N
				POWER
				PF
				KW
				KVA
KVAH	KWH		FREQ	KVAR
MAX/MIN	VOLTS	AMPS	POWER	PHASE
LIMITS				NEXT

!Repeat this procedure until new Time Delay is entered.

!When complete, middle display blanks and lower display

Indicates the new Time Delay.

See Chapter 14 to Exit.

54 EPM 5000 series Advanced Power Meters GE Multilin