GE EPM 5200, EPM 5300, EPM 5350 instruction manual Ethernet Option Setup, Description LED Functions

CHAPTER 16: ETHERNET OPTION

See the Table below for a description of the Status LED functions.

LED	Description	LED Functions
1	Serial Port	Lights solid green to indicate Channel 1 is IDLE.
	(Channel) 1	Blinks green to indicate Channel 1 is connected
	Status	to the network and ACTIVE.
2	Serial Port	Lights solid yellow to indicate Channel 2 is IDLE.
	(Channel) 2	Blinks yellow to indicate Channel 2 is connected
	Status	to the network and ACTIVE.
		(Not used by this device; reserved for future use)
3	Diagnostics	Blinks or lights solid red in combination with the
		green (Channel 1) LED to indicate
		DIAGNOSTICS and ERROR DETECTION.
		Red solid, green (Channel 1) blinking:
		1x: EPROM checksum error
		2x: RAM error
		3x: Network controller error
		4x: EEPROM checksum error
		5x: Duplicated IP address on network*
		6x: Software does not match hardware*
		Red blinking, green (Channel 1) blinking:
		4x: Faulty network connection*
		5x: No DCHP response received*
4	Network Link	Lights solid green to indicate network port is
	Status	connected to the network.
		* non-fatal error

16.2: Ethernet Option Setup

This chapter covers the required steps to get the Ethernet Interface on-line and working. There is only one method used to log into the Ethernet Server and set up the IP address:

•Network Port Login: make a Telnet connection to the network port (9999).

It is important to consider the following points before logging into and configuring the Ethernet Interface:

•The Ethernet Interface’s IP address must be configured before a network connection is available.

•Only one person at a time may be logged into the network port. This eliminates the possibility of several people trying to configure the Ethernet Interface simultaneously.

92 EPM 5000 series Advanced Power Meters GE Multilin