Installation Instructions
INSTALL THE FAUCET (CONT.)
6.Feed the water tube up through the faucet base.
Then push the tube into the fitting on the bottom of the faucet body. It should go in about 3/4″. Pull tube slightly to make sure it is secure.
Faucet Body
Gasket
Base | Sink |
Butterfly Bracket 
7.Push the faucet body down into the faucet base and twist clockwise until it clicks into place.
NOTE: You can install the faucet so the handle is on the right or the left side.
If you want the faucet handle on the right, position the handle at the back of the faucet base before turning clockwise.
If you want the faucet handle on the left, position the handle at the front of the faucet base before turning clockwise.
Faucet | Faucet |
Faucet handle on the RIGHT | Faucet handle on the LEFT |
7.Locate the hole at the rear of the base. Insert set screw and begin to tighten by hand. Finish tightening with the allen wrench provided
in the packet .
10