Contaminant | GE GXSV65R, GXSL55R specification

Performance Data Sheet.

	Organic Chemicals Reduced by Chloroform Surrogate Testing
	Avg.1 Influent	Max. Effluent		Avg.1 Influent	Max. Effluent
Contaminant	(μg/L)2	(μg/L)2	Contaminant	(μg/L)2	(μg/L)2
Alachlor	50	1.03	Haloketones (HK):
Atrazine	100	3.03	1,1-dichloro-2-propanone	7.2	0.14
Benzene	81	1.03	1,1,1-trichloro-2-propanone	8.26	0.34
Carbofuran	190	1.03	Heptachlor (H-34, Heptox)	80	0.43
Carbon Tetrachloride	78	1.84	Heptachlor Epoxide	10.76	0.26
Chlorobenzene	77	1.03	Hexachlorobutadiene	44	1.03
Chloropicrin	15	0.24	Hexachlorocyclopentadiene	60	0.0023
2,4-D	110	1.74	Lindane	55	0.013
Dibromochloropropane (DBCP)	52	0.023	Methoxychlor	50	0.13
o-Dichlorobenzene	80	1.03	Pentachlorophenol	96	1.03
p-Dichlorobenzene	40	1.03	Simazine	120	4.03
1,2-Dichloroethane	88	4.85	Styrene	150	0.53
1,1-Dichloroethylene	83	1.03	1,1,2,2-Tetrachloroethane	81	1.03
cis-1,2-Dichloroethylene	170	0.53	Tetrachloroethylene	81	1.03
trans-1,2-Dichloroethylene	86	1.03	Toluene	78	1.03
1,2-Dichloropropane	80	1.03	2,4,5-TP (silvex)	270	1.63
cis-1,3-Dichloropropylene	79	1.03	Tribromoacetic acid	42	1.03
Dinoseb	170	0.24	1,2,4-Trichlorobenzene	160	0.53
Endrin	53	0.594	1,1,1-Trichloroethane	84	4.64
Ethylbenzene	88	1.03	1,1,2-Trichloroethane	150	0.53
Ethylene Dibromide (EDB)	44	0.023	Trichlorothylene	180	1.03
Haloacetonitriles (HAN):			Trihalomethanes (includes):	300	15
Bromochloroacetonitrile	22	0.54	Chloroform (surrogate chemical)
Dibromoacetonitrile	24	0.64	Bromoform
Dichloroacetonitrile	9.6	0.24	Bromodichloromethane
Trichloroacetonitrile	15	0.34	Chlorodibromomethane
			Xylenes (total)	70	1.03

1Influent challenge levels are average influent concentrations determined in surrogate qualification testing.

2μg/L means Micrograms Per Liter.

3Maximum product water level was not observed but was set at the detection limit of the analysis.

4Maximum product level is set at a value determined in surrogate qualification testing.

Testing was performed under standard laboratory conditions; actual performance may vary.

5Chemical reduction percent and maximum product water level calculated at chloroform 95% breakthrough point as determined in surrogate qualification testing.

6The surrogate test results for heptachlor Epoxide demonstrated a 98% reduction. These data were used to calculate an upper occurrence concentration, which would produce a maximum product water level at the MCL.

NOTE: Substances reduced are not necessarily in your water. Filter must be maintained according to manufacturer’s instructions, including replacement of filter cartridges.

WARNING:Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that contain filterable cysts.