FIRMWARE UPDATE
Firmware Update Procedure
To Begin the update procedure the unit’s Boot Loader must be activated. To activate the Boot Loader follow the procedure below:
If the unit is already powered on, the following
1.Connect
2.Type the command: #ACTIVEBOLO\r
3.
If the unit is not powered on, follow the instructions below to activate the Boot Loader:
1.Connect
2.Make sure Hyperterminal is set to the following:
a.Baud rate = 19200
b.Stop bits = 1
c.Data bits = 8
d.Flow control = None
3.Press the following three buttons on the front panel of the Matrix simultaneously, while
a.select
b.< (left cursor)
c.> (right cursor)
Once the Boot Loader is activated the following message should appear:
DVI8x8 Boot Loading
================== Main Menu ============================
Download new program | 1 |
Cancel | 2 |
=========================================================
39