Falcon SG800-1T, SG800-2T specifications Storing the UPS and Batteries, FCC Considerations

Page 22

The following precautions should be observed by a qualified technician when working with batteries:

1.Remove watches, rings, or other metal objects.

2.Use tools with insulated handles.

3.Wear rubber gloves and boots.

4.Do not lay tools or metal parts on top of batteries.

4.Storing the UPS and Batteries

Should you need to store the UPS for a long period, fully recharge the battery just prior to storage and recharge the battery every 4 months by plugging the UPS into a power outlet. It is recommended that the batteries charge for 24 hours after long-term storage.

5.FCC Considerations

This equipment generates and uses radio frequency energy and if not installed and used properly in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. All models covered in this manual have been tested and found to comply with the limits for a Class A computing device, in accordance with the specifications in FCC regulations, Part 15, Subpart J, which are designed to provide reasonable protection against such interference.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

a. Reorient or relocate the receiving antenna.

b. Increase the separation between the equipment and the receiver.

c. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

d. Consult the dealer or an experienced radio/television technician for assistance.

20

Image 22
Contents Owners Operating Manual Table of Contents SG Series ON-LINE UPS System Block Diagram Important Safety Instructions True Regenerative On-Line Design Input Power Factor CorrectionExtended Battery Bank Option Microprocessor ControlInstallation Instructions Page SW1 Installation Procedure for Extended Battery Banks Typical Extended Battery Bank & UPS InterconnectionSG800VA-3kVA Tower Extended Battery Bank Selection Guide For 800VA-1KVA ModelsLoad Level Indicator Leds OperationInverter Indicator LED Category two alarms Audible AlarmsCategory one alarms = UPS Output Voltage is of RangeSG800-1T & SG1K-1T Typical Rear Panel Overview Rear Panel DetailsSG800-2T & SG1K-2T Typical Rear Panel Overview SG1.5K-1T, SG2K-1T & SG3K-1T Typical Rear Panel Overview SG1.5K-2T, SG2K-2T & SG3K-2T Typical Rear Panel OverviewBreaker Location Communications InterfacesSupported Protocols With on-bypass signal No on-bypass signalTypical Falcon Dry Contact Relay Board Typical Falcon Opto-coupler Interface Card No-bypass signalOpto Board Internal Circuitry APC Style Dry Contact Relay Board APC Style BoardBattery Life vs. Temperature Care & MaintenanceBattery Replacement Storing the UPS and Batteries FCC ConsiderationsSUPPORT@FALCONUPS.COM Technical SupportRequesting Technical Information or Support 800.842.6940 Falcon Web SupportNEW Product Limited Warranty Falcon ELECTRIC, INCSG SeriesTM UPS Plus 2kVA 3kVA 2kVA & 3kVA