Enterasys Networks C2RPS-SYS manual Using the SecureStack C2 Manual Set

Page 14

Using the SecureStack C2 Manual Set

Using the SecureStack C2 Manual Set

Other manuals have been developed for the SecureStack C2 non‐PoE switch devices that can be connected to the RPS for power redundancy.

Caution: The RPS does not support PoE-compliant SecureStack switches. Do not try to connect the power cable from this RPS to any SecureStack switch with a “P” suffix in the model name, such as C2xxxxx-xxP. Otherwise, damage to the device may result.

Precaución: El RPS no es compatible con switches SecureStack C2 con PoE. No intente conectar el cable de corriente del RPS a ningún switch SecureStack C2 que tenga el sufijo “P” en el nombre del modelo, tal como C2xxxxx-xxP. De lo contrario, el dispositivo puede dañarse.

The SecureStack C2 switch manuals explain how to install the switch device, connect network cable segments to the SecureStack switch device, and configure the switch device using the command line interface commands described in the SecureStack C2 Configuraton Guide.

Note: Connection of the RPS system does not require the reconfiguration of the connected Ethernet Switch.

Each manual is written for qualified personnel who are responsible for installing the switch device and also have a general working knowledge of data communications networks and their physical layer components.

xii About this Guide

Page 13 Page 15
Image 14
Page 13 Page 15
Contents SecureStack C2 Redundant Power System Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Figures Structure of This Guide Using This GuideAbout this Guide Using the SecureStack C2 Manual Set Conventions Used in This Guide Following conventions are used in this guideConventions Used in This Guide Xiv About this Guide Introduction RPS OverviewPower supply slot cover Captive screw 2 per cover C2RPS-CHAS8 ChassisC2RPS-PSM Power Supply Module C2RPS-PSM front viewRPS Supporting a Group of Switches up to eight RPS Deployment StrategiesGetting Help Support@enterasys.comGetting Help Introduction Required Tools InstallationUnpacking Chassis and Power Supply Modules Installing C2RPS-PSMs Replacing an Installed C2RPS-PSM C2RPS-PSM InstallationInstalling C2RPS-CHAS8 into the Rack Guidelines for Rackmount InstallationRack Mounting the Chassis Connecting the PSM Cables and AC Power Cords Fastening the C2RPS-CHAS8 to the RackC2RPS-PSM Cable C2RPS-PSM Cable and AC Power Cord Connections Specifications C2RPS-CHAS8 Chassis SpecificationsC2RPS-PSM Specifications C2RPS-PSM Redundant Power Supply Output ConnectorCompliance Standards Table A-4 Compliance StandardsCompliance Standards Specifications
Top Page Image Contents